Cisco Systems AS5400XM, AS5350XM manual Universal Port and Dial-Only Feature Cards

C H A P T E R 5

Universal Port and Dial-Only Feature Cards

This chapter describes universal port and dial-only feature cards and includes the following sections:

•Overview, page 5-1

•Online Insertion and Removal of the Universal Port or Dial-Only Feature Card, page 5-3

•System Processing Engine Firmware, page 5-10

•Getting Help, page 5-10

•Where to Go Next, page 5-10

Overview

Two different types of Nextport digital signal processor (DSP) feature cards are available for

Cisco AS5350XM and Cisco AS5400XM universal gateways. (See Figure 5-1.)

•Universal port feature card—The universal port feature card supports 60 (NP-60) to 108 (NP-108) voice, fax, and dial calls in Cisco AS5350XM and Cisco AS5400XM universal gateways.

•Dial-only feature card—The dial-only feature card supports 60 (DL-60) to 108 (DL-108) dial calls in Cisco AS5350XM and Cisco AS5400XM universal gateways. It does not support voice or fax services.

Note Dial services include modem calls (all modulations), ISDN digital calls, V.110 data calls, and V.120 data calls. Modem pass-through calls are not included in dial services.

For configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide. For information on voice and fax commands, see the Cisco IOS Voice Configuration Library for your Cisco IOS software release at Cisco.com.

You can install a universal port or dial-only feature card in any card slot in the universal gateway chassis. The universal port and dial-only feature cards do not require external connections.

Note The dial-only feature card is configured in the same way as the universal port feature card. This allows the dial-only feature card to be used with your existing software configuration.

Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide

78-17406-01 5-1