C H A P T E R 4
Channelized T3 Feature Card
This chapter describes the channelized T3 (CT3) feature card and includes the following sections:
•Overview, page
•Online Insertion and Removal of the CT3 Feature Card, page
•Getting Help, page
•Where to Go Next, page
Overview
The CT3 feature card provides physical line termination for a channelized T3 ingress trunk line. It uses an onboard multiplexer to multiplex 28 channelized T1 lines into a single channelized T3 line. (See Figure
Figure 4-1 CT3 Feature Card
29029
Note The Cisco AS5350XM and Cisco AS5400XM universal gateways each support only one type of WAN feature card at a time. See Chapter 7, “Troubleshooting,” for more information.
The CT3 feature card provides physical line termination for up to 672 DS0 channels and uses onboard
You can use the bantam jack ports on the feature card to monitor a T1 line or to test any of the individual T1 channels in drop and insert mode.
You can install a CT3 feature card in any feature card slot in a universal gateway chassis.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
|
|
| |
|
|