Chapter 3
Chapter 3:
Installation
Physical Installation
There are three ways to place the Router. The first way is to place it horizontally on a surface, so it sits on its four rubber feet. The second way is to stand the Router vertically on a surface. The third way is to mount it on a wall.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Set the Router on a flat surface near an electrical outlet.
WARNING: Do not place excessive weight on top of the Router; too much weight could damage it.
Vertical Placement
1.Line up the edges of the Router with the two stands.
2.Insert the Router into the stands.
3.Set the Router on a flat surface near an electrical outlet.
Installation
Wall-Mounting Placement
The Router has two
Two screws are needed to mount the Router.
Suggested Mounting Hardware
3.0 | |||
|
|
†Note: Mounting hardware illustrations are not true to scale.
NOTE: Linksys is not responsible for damages incurred by insecure
Follow these instructions:
1.Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.
2.Drill two holes into the wall. Make sure the holes are 64.4 mm (2.535 inches) apart.
3.Insert a screw into each hole and leave 5 mm (0.2 inches) of its head exposed.
4.Maneuver the Router so the
5.Place the
64.4 mm
Print this page at 100% size. Cut along the dotted line, and place on the wall to drill precise spacing.
Wall Mounting Template