Cisco Systems RVL200 manual Configuration when Both Gateways Use Dynamic IP Addresses

Appendix I Gateway-to-Gateway VPN Tunnel

7.The WAN IP address (B.B.B.B) of the RV082 will be automatically detected.

For the Local Security Group Type, select Subnet. Enter the RV082’s local network settings in the IP Address and Subnet Mask fields.

RV082 VPN Settings

8.For the Remote Security Gateway Type, select IP address. Enter the RVL200’s WAN IP address in the IP Address field.

9.For the Remote Security Group Type, select Subnet. Enter the RVL200’s local network settings in the IP Address and Subnet Mask fields.

10.In the IPSec Setup section, select the appropriate encryption,authentication,andotherkeymanagement settings. (These should match the settings of the RVL200.)

11.In the Preshared Key field, enter a string for this key, for example, 13572468.

RV082 IPSec Setup Settings

12.If you need more detailed settings, click Advanced Settings. Otherwise, click Save Settings.

Configuration of PC 1 and PC 2

Verify that PC 1 and PC 2 can ping each other (refer to Windows Help for more information). If the computers can ping each other, then you know the VPN tunnel is configured correctly.

Configuration when Both Gateways Use Dynamic IP Addresses

This example assumes both Gateways are using dynamic IP addresses. If the Remote Gateway uses a static IP address, refer to “Configuration when the Remote Gateway Uses a Static IP Address.” If only the Remote Gateway uses a dynamic IP address, refer to “Configuration when the Remote Gateway Uses a Dynamic IP Address.”

RV082	RVL200
Dynamic IP: B.B.B.B with	Dynamic IP: A.A.A.A with
Domain Name: www.abc.com	Domain Name: www.xyz.com
LAN: 192.168.1.1	LAN: 192.168.5.1

Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using

Dynamic IP

NOTE: Each computer must have a network adapter installed.

Configuration of the RVL200

Follow these instructions for the first VPN Router, designated RVL200. The other VPN Router is designated the RV082.

1.Launch the web browser for a networked computer, designated PC 1.

2.Access the web-based utility of the RVL200. (Refer to “Chapter 4: Advanced Configuration” for details.)

3.Click the IPSec VPN tab.

4.Click the Gateway to Gateway tab.

5.Enter a name in the Tunnel Name field.

6.For the VPN Tunnel setting, select Enable.

7.The WAN IP address (A.A.A.A) of the RVL200 will be automatically detected.

For the Local Security Group Type, select Subnet. Enter the RVL200’s local network settings in the IP Address and Subnet Mask fields.

4-Port SSL/IPSec VPN Router 85