Chapter 4 | Advanced Configuration |
SNMP > Views
Configure this screen to allow or deny access to SNMP features.
SNMP > Views
Views
View Table
View Name Select the appropriate view name. There are two default views:
Default
This displays the default SNMP views for read and read/write views, including the following MIB OIDs:
•1 included
•1.3.6.1.6.3.13 excluded
•1.3.6.1.6.3.16 excluded
•1.3.6.1.6.3.18 excluded
•1.3.6.1.6.3.12.1.2 excluded
•1.3.6.1.6.3.12.1.3 excluded
•1.3.6.1.6.3.15.1.2 excluded
•1.3.6.1.4.1.3955.2.1.13 excluded (Linksys MIB community table)
•1.3.6.1.4.1.3955.2.2.8 excluded (disable/enable SNMP, advanced management SNMP status)
•1.3.6.1.4.1.3955.2.2.16 excluded (trap manager table)
DefaultSuper
This displays the default SNMP view for administrator views. It does not block any subtree OID.
New View Name Enter a new view name.
SubTree ID Tree Linksys supports
•
•
•
•
•
•
•
•
•
•
•
•
•
View Type Select included if the defined OID will be included in the selected SNMP view. Select excluded if the defined OID will be excluded.
Click Add to List, and configure as many entries as you would like, up to a maximum of 20. To delete an entry, select it and click Delete.
Click Save Settings to save your changes, or click Cancel Changes to undo them.
SNMP > Group Profile
Define the SNMP groups and their features, including SNMP version usage and access rights.
SNMP > Group Profile
Group Profile
Group Table
Group Name Enter a name for the group, up to 30 characters.
44 |