Cisco Systems 78-16356-01 manual Attaching Front Rail to the Right Side of the Rack

Chapter 3 Installing the GSS

Installing Your GSS

4.Select a location in the rack to mount the GSS and attach the front end of the right outer telescopic rail to the right side of the rack, as show in Figure 3-4.

Note Racks that contain tapped mounting holes do not require the cage nuts (3) shown in Figure 3-4.

Figure 3-4 Attaching Front Rail to the Right Side of the Rack

1 2

3

119962

1

2

Round head screw and washer 3 Cage nut

Right outer telescopic rail—front

5.Extend the middle rail from the front of the rack to have free access to the two adjustment screws located at the rear of the outer telescopic rail (Figure 3-5). Loosen the two adjustment screws to leave some play when attaching the back end of the outer telescopic rail to the rack, then push the middle rail back into its original position. After the rail is attached to the rack, you can tighten the two adjustment screws.

	Cisco Global Site Selector 4491 Hardware Installation Guide
3-8	78-16356-01