Emulex Printer Server manual Initialize, Below MIO Version, Delaymin

Command Reference Guide 11

Initialize

Initialize NETQue printer servers and NETJet printer servers installed in Hewlett-Packard printers with MIO version 6.0 or above.

>Server>> initialize [server] [delay delay_min] [cancel] [flash] [default] [disabled]

server	Reinitializes the printer server.
delay	Indicates reinitialization will not take place until
	after a specified period of time.
delay_min	A number specifying the amount of delay in
	minutes. The default is 1 minute.
cancel	Cancels a previously entered initialize command
	if entered within the delay time specified in the
	initial command.
flash	Causes printer server software to download
	from the host to flash memory if the printer
	server is configured for a network load.
default	Resets the printer server to factory defaults. IP
	address and subnet mask are reset to none.
disabled	Prevents any connections after initialization. To
	enable connections, enter the initialize
	command through a remote console without this
	option.

When the initialize printer server command is issued with a delay, a warning message is sent every 30 minutes to all logged in ports. Five minutes before initialization, the warning is broadcast every minute. When the printer server is reinitialized, all options modified by Set commands are reset to their permanent values, and all options modified by Change and Define commands take effect.

Below MIO Version 6.0

The initialize command will not reset NETJet printer servers in Hewlett Packard printers that do not have MIO version 6.0 or above. To reset these printer servers, recycle power on the printer.