Cabletron Systems WPIM-RT1 manual Related Manuals

Page 12

Introduction

Appendix B, FCC Part 68 - User’s Information, explains the FCC Rules for the WPIM-RT1.

RELATED MANUALS

Refer to the manual included with the host platform in which the WPIM-RT1 is installed to supplement the procedures and other technical data provided in this manual. This manual references procedures in these manuals, where appropriate, but does not repeat them.

The following manuals may help the user to set up and manage the WPIM-RT1:

Cabletron Systems WPIM Setup Guide

Cabletron Systems HSIM-W6 Installation Guide

Cabletron Systems QuickSET Configuration Guide

Cabletron Systems HSIM-SSA710 User’s Guide

Cabletron Systems HSIM-SSA710 Quick START

Cabletron Systems Cyberswitch CSX400 and CSX400-DC Installation Guide

Cabletron Systems Local Management for CSX400, CSX400-DC, CSX500, HSIM-W6 and HSIM-W84

The manuals referenced above can be obtained on the World Wide Web in Adobe Acrobat Portable Document Format (PDF) at the following site:

http://www.cabletron.com/

NOTE

Manuals for the WAN host platforms can also be found on the QuickSet CD-ROM that is included with the host platform.

x

WPIM-RT1 User’s Guide

Image 12
Contents WPIM-RT1 Page FCC Notice WPIM-RT1 User’s GuideIndustry Canada Notice Vcci NoticeExclusion of Warranty and Disclaimer of Liability Cabletron SYSTEMS, INC. Program License AgreementCabletron Software Program License United States Government Restricted Rights Declaration of Conformity PO Box Rochester, NHWPIM-RT1 User’s Guide Contents Viii WPIM-RT1 User’s Guide Using this Manual IntroductionStructure of this Guide Related Manuals Document Conventions Following conventions are used throughout this documentGetting Help Your email addressChapter Overview WPIM-RT1 Features WAN ProtocolsIsdn MIB SupportChapter Setup and Installation Installing the WPIM-RT1Pre-Installation Installing the WPIM-RT1Unpacking the WPIM-RT1 Post-Installation Installing the WPIM-RT1Connecting the WAN Cable to the WPIM-RT1 Host Platform LEDsRequired Management Operations Connecting the WAN cable to the WPIM-RT1 WPIM-RT1 User’s Guide Chapter Local Management WAN Physical Configuration Screen WAN Physical Configuration Screen FieldsDisplays the next interface available to be used Wpim Line Configuration Fields Wpim Timeslot Configuration Table Sample Timeslot ConfigurationSample Configuration WAN Interface Configuration Screen WAN Interface Configuration Screen FieldsFrame Relay as the Protocol Manager PPP as the Protocol Manager WAN Interface Configuration Screen PPPCommand Fields and Interface Table Fields Full T1 Configuration Using PPP Configuration Information Required by User1 T1 Physical Configuration 2 T1 Interface Configuration Fractional T1 Configuration Using PPP Fractional T1 ConfigurationFractional T1 Configuration Using PPP Enter Frame Relay Configuration Frame Relay ConfigurationFrame Relay Physical Configuration Frame Relay Configuration Frame Relay Interface Configuration Frame Relay Configuration WPIM-RT1 User’s Guide Appendix a Specifications Physical PropertiesEnvironmental Requirements Regulatory ComplianceT1 Interface Cabling Cable Assemblies and PinoutsAppendix B FCC Part 68 USER’S Information REN/SOC FIC UsocAppendix B FCC Part 68 User’s Information Being duly sworn, state My commission expires