Cabletron Systems WPIM-RT1 manual Full T1 Configuration Using PPP

Page 33

Full T1 Conﬁguration Using PPP

3.3FULL T1 CONFIGURATION USING PPP

This section provides step-by-step instructions for conﬁguring the WPIM-RT1 to use a full T1 circuit in a PPP environment. This simpliﬁed example assumes the setup shown in Figure 3-6using a CSX400 with a WPIM-RT1 installed at Site #1. Conﬁgurations may vary depending on the host platform.

SITE #1

Telco Cloud

24 Timeslots

Figure 3-6 Full T1 Conﬁguration

SITE #2

24 Timeslots

1482_05

The line conﬁguration information shown in Table 3-1must be supplied by the service provider.

Table 3-1 Telco Conﬁguration Information

Configuration Information	Configuration Information
Required by User	Supplied by Service Provider


Line Coding	B8ZS or AMI

Frame Type	ESF or D4

Clock Source	Loop Timing or Local Timing

WPIM-RT1 User’s Guide

3-11

Image 33

Contents WPIM-RT1 Page WPIM-RT1 User’s Guide FCC NoticeVcci Notice Industry Canada NoticeExclusion of Warranty and Disclaimer of Liability Cabletron SYSTEMS, INC. Program License AgreementCabletron Software Program License United States Government Restricted Rights PO Box Rochester, NH Declaration of ConformityWPIM-RT1 User’s Guide Contents Viii WPIM-RT1 User’s Guide Using this Manual IntroductionStructure of this Guide Related Manuals Following conventions are used throughout this document Document ConventionsYour email address Getting HelpChapter Overview WAN Protocols WPIM-RT1 FeaturesIsdn MIB SupportInstalling the WPIM-RT1 Chapter Setup and InstallationPre-Installation Installing the WPIM-RT1Unpacking the WPIM-RT1 Installing the WPIM-RT1 Post-InstallationConnecting the WAN Cable to the WPIM-RT1 Host Platform LEDsRequired Management Operations Connecting the WAN cable to the WPIM-RT1 WPIM-RT1 User’s Guide Chapter Local Management WAN Physical Conﬁguration Screen Fields WAN Physical Configuration ScreenDisplays the next interface available to be used Wpim Line Conﬁguration Fields Sample Timeslot Conﬁguration Wpim Timeslot Conﬁguration TableSample Conﬁguration WAN Interface Conﬁguration Screen Fields WAN Interface Configuration ScreenFrame Relay as the Protocol Manager WAN Interface Conﬁguration Screen PPP PPP as the Protocol ManagerCommand Fields and Interface Table Fields Configuration Information Required by User Full T1 Configuration Using PPP1 T1 Physical Conﬁguration 2 T1 Interface Conﬁguration Fractional T1 Conﬁguration Fractional T1 Configuration Using PPPFractional T1 Conﬁguration Using PPP Enter Frame Relay Conﬁguration Frame Relay ConfigurationFrame Relay Physical Conﬁguration Frame Relay Conﬁguration Frame Relay Interface Conﬁguration Frame Relay Conﬁguration WPIM-RT1 User’s Guide Physical Properties Appendix a SpecificationsEnvironmental Requirements Regulatory ComplianceCable Assemblies and Pinouts T1 Interface CablingREN/SOC FIC Usoc Appendix B FCC Part 68 USER’S InformationAppendix B FCC Part 68 User’s Information Being duly sworn, state My commission expires