Cabletron Systems WPIM-RT1 manual Chapter Local Management

CHAPTER 3

LOCAL MANAGEMENT

This chapter explains how to configure the WPIM-RT1 through Local Management for T1 service on the CSX400 or the HSIM-W6. Refer to the Cabletron Systems HSIM-SSA710 User’s Guide for information on Local Management for the HSIM-SSA710.

The WAN Physical Configuration screen and the WAN Interface Configuration screen appear as Local Management menu selections when you install the WPIM-RT1 into a host module. Refer to the host platform User’s Guide for instructions about how to set up and access Local Management.

Sections of this chapter include:

•The WAN Physical Configuration screen, Section 3.1

•The WAN Interface Configuration screen, Section 3.2

•Full T1 Configuration using PPP (Point-to-Point Protocol), Section 3.3

•Fractional T1 Configuration using PPP, Section 3.4

•Frame Relay Configuration, Section 3.5

Read Section 3.1 and Section 3.2 to gain an understanding of the WPIM-RT1 Local Management screens for T1. Section 3.3 through Section 3.5 provide examples for setting up the WPIM-RT1 for full or fractional T1 in a PPP environment, or for configuring the WPIM-RT1 for Frame Relay in the T1 mode.

Navigate through the WPIM Local Management Screens by

TIP using the following keyboard commands:

Arrow keys to move up, down, right or left within the screen.

SPACE bar to toggle between selections in a field.

ENTER (RETURN) to implement a selection.

WPIM-RT1 User’s Guide 3-1