Cabletron Systems WPIM-RT1 manual Industry Canada Notice, Vcci Notice

Page 4

Notice

INDUSTRY CANADA NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements documents (s). The department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the ringer equivalence Numbers of all the devices does not exceed 5.

VCCI NOTICE

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

ii

WPIM-RT1 User’s Guide

Image 4
Contents WPIM-RT1 Page FCC Notice WPIM-RT1 User’s GuideIndustry Canada Notice Vcci NoticeCabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License United States Government Restricted Rights Declaration of Conformity PO Box Rochester, NHWPIM-RT1 User’s Guide Contents Viii WPIM-RT1 User’s Guide Introduction Using this ManualStructure of this Guide Related Manuals Document Conventions Following conventions are used throughout this documentGetting Help Your email addressChapter Overview WPIM-RT1 Features WAN ProtocolsIsdn MIB SupportChapter Setup and Installation Installing the WPIM-RT1Installing the WPIM-RT1 Pre-InstallationUnpacking the WPIM-RT1 Post-Installation Installing the WPIM-RT1Host Platform LEDs Connecting the WAN Cable to the WPIM-RT1Required Management Operations Connecting the WAN cable to the WPIM-RT1 WPIM-RT1 User’s Guide Chapter Local Management WAN Physical Configuration Screen WAN Physical Configuration Screen FieldsDisplays the next interface available to be used Wpim Line Configuration Fields Wpim Timeslot Configuration Table Sample Timeslot ConfigurationSample Configuration WAN Interface Configuration Screen WAN Interface Configuration Screen FieldsFrame Relay as the Protocol Manager PPP as the Protocol Manager WAN Interface Configuration Screen PPPCommand Fields and Interface Table Fields Full T1 Configuration Using PPP Configuration Information Required by User1 T1 Physical Configuration 2 T1 Interface Configuration Fractional T1 Configuration Using PPP Fractional T1 ConfigurationFractional T1 Configuration Using PPP Enter Frame Relay Configuration Frame Relay ConfigurationFrame Relay Physical Configuration Frame Relay Configuration Frame Relay Interface Configuration Frame Relay Configuration WPIM-RT1 User’s Guide Appendix a Specifications Physical PropertiesEnvironmental Requirements Regulatory ComplianceT1 Interface Cabling Cable Assemblies and PinoutsAppendix B FCC Part 68 USER’S Information REN/SOC FIC UsocAppendix B FCC Part 68 User’s Information Being duly sworn, state My commission expires