Cabletron Systems manual Unpacking the WPIM-RT1, Pre-Installation, Installing the WPIM-RT1

Chapter 2: Setup and Installation

2.1.1Unpacking the WPIM-RT1

Both the WPIM and the host platform in which the WPIM is installed are static sensitive devices. Use an antistatic strap and follow all static safe precautions during installation. Failure to do so could result in damage to the WPIM and the host platform receiving it.

1.Carefully remove the WPIM-RT1 from the shipping box.

2.Visually inspect the WPIM-RT1. If there are any signs of damage, contact Cabletron Systems immediately. Refer to Getting Help.

2.1.2Pre-Installation

To prepare the host platform for the WPIM-RT1, proceed as follows:

1.Turn off and disconnect the host platform from the power source.

2.Mark all network cables attached to the host platform for ease of re-installation.

3.Disconnect all network cables attached to the host platform.

4.Refer to detailed instructions contained in the host platform’s user guides to remove the chassis cover, if applicable. Power must be unplugged from the chassis before removing the cover.

2.1.3Installing the WPIM-RT1

To install the WPIM-RT1 into the device, refer to Figure 2-2and complete the following steps:

When removing an existing WPIM, pull the module straight up

!to avoid damaging the connector.

CAUTION

1.Remove the blank faceplate from the appropriate WAN slot by removing the three WPIM screws that secure it to the standoffs.

2.Orient the WPIM-RT1 as shown in Figure 2-2.

3.Carefully insert the WPIM-RT1 connector into the WPIM connector pins on the device.

2-2 WPIM-RT1 User’s Guide