Cabletron Systems manual Post-Installation, Installing the WPIM-RT1

Page 19

Installing the WPIM-RT1

4.Press down firmly on the WPIM-RT1 until the pins slide all the way into the connector. Ensure that the WPIM-RT1 seats flush on the standoffs.

5.Secure the WPIM-RT1 to the three standoffs with the WPIM screws.

WPIM Screws

WPIM

Connector

WPIM

WPIM

Connector Pins

Standoffs

Figure 2-2 Installing the WPIM-RT1

2.1.4Post-Installation

1.Reinstall the cover if applicable.

2.Refer to the host platform user’s guide to reinstall the network cables and refer to Appendix A for cabling information for the WPIM-RT1. Do not connect the WAN cable at this point.

3.Refer to instructions contained in the host platform user’s guide to reapply power.

4.After reapplying power, check the LEDs for the following conditions:

•Verify that the PWR LED is on, indicating that the device is receiving power.

•After the host platform runs a self test, the CPU LED blinks green indicating normal operation.

•If the CPU LED remains red, contact Cabletron Systems.

WPIM-RT1 User’s Guide

2-3

Image 19

Contents WPIM-RT1 Page WPIM-RT1 User’s Guide FCC NoticeVcci Notice Industry Canada NoticeCabletron SYSTEMS, INC. Program License Agreement Exclusion of Warranty and Disclaimer of LiabilityCabletron Software Program License United States Government Restricted Rights PO Box Rochester, NH Declaration of ConformityWPIM-RT1 User’s Guide Contents Viii WPIM-RT1 User’s Guide Introduction Using this ManualStructure of this Guide Related Manuals Following conventions are used throughout this document Document ConventionsYour email address Getting HelpChapter Overview MIB Support WPIM-RT1 FeaturesWAN Protocols IsdnInstalling the WPIM-RT1 Chapter Setup and InstallationInstalling the WPIM-RT1 Pre-InstallationUnpacking the WPIM-RT1 Installing the WPIM-RT1 Post-InstallationHost Platform LEDs Connecting the WAN Cable to the WPIM-RT1Required Management Operations Connecting the WAN cable to the WPIM-RT1 WPIM-RT1 User’s Guide Chapter Local Management WAN Physical Conﬁguration Screen Fields WAN Physical Configuration ScreenDisplays the next interface available to be used Wpim Line Conﬁguration Fields Sample Timeslot Conﬁguration Wpim Timeslot Conﬁguration TableSample Conﬁguration WAN Interface Conﬁguration Screen Fields WAN Interface Configuration ScreenFrame Relay as the Protocol Manager WAN Interface Conﬁguration Screen PPP PPP as the Protocol ManagerCommand Fields and Interface Table Fields Configuration Information Required by User Full T1 Configuration Using PPP1 T1 Physical Conﬁguration 2 T1 Interface Conﬁguration Fractional T1 Conﬁguration Fractional T1 Configuration Using PPPFractional T1 Conﬁguration Using PPP Enter Frame Relay Conﬁguration Frame Relay ConfigurationFrame Relay Physical Conﬁguration Frame Relay Conﬁguration Frame Relay Interface Conﬁguration Frame Relay Conﬁguration WPIM-RT1 User’s Guide Regulatory Compliance Appendix a SpecificationsPhysical Properties Environmental RequirementsCable Assemblies and Pinouts T1 Interface CablingREN/SOC FIC Usoc Appendix B FCC Part 68 USER’S InformationAppendix B FCC Part 68 User’s Information Being duly sworn, state My commission expires