REQUIREMENTS/SPECIFICATIONS
TPIM-F2
The
RX | TX | LNK |
|
| |
|
|
Figure 2-6. The TPIM-F2
Note: The transmitter power levels and receive sensitivity levels given are Peak Power Levels after optical overshoot. A Peak Power Meter must be used to correctly compare the values given to those measured on any particular port. If Power Levels are being measured with an Average Power Meter, then 3 dBm must be added to the measurement to correctly compare those measured values to the values listed (i.e.
Parameter | Typical | Worst | Worst Case Typical | |
Receive | Value | Case | Budget | Budget |
|
|
|
| |
Sensitivity: | — | — | ||
Peak Input |
|
|
|
|
Power: | — | — | ||
Transmitter Power |
|
|
| |
50/125 ∝m |
|
|
|
|
fiber: | 13.0 dB | 17.5 dB | ||
62.5/125 ∝m |
|
|
|
|
fiber: | 16.0 dB | 20.5 dB | ||
100/140 ∝m |
|
|
|
|
fiber: | 19.0 dB | 23.5 dB | ||
Error Rate: | Better than |
|
|
Page