Cabletron Systems SEH-34, SEH-32 manual Free-Standing Installation, Shelf or Table-top Installation

INSTALLATION

3.You will need a pencil for this step. With the wall mounting brackets attached to the SEH, position the SEH against the wall where it will be permanently mounted with the network port facing down. Use the pencil to mark the wall location for the four pilot holes.

4.Set the SEH aside and carefully drill four 1/4" pilot holes, one for each of the Molly screw anchors and insert the four Molly screw anchors into the holes just drilled.

5.Tighten each of the anchor screws until the anchor expands holding the anchor firmly in the wall, then remove the screws completely.

6.Position the SEH on the wall over the anchors and reinstall the four anchor screws to attach the SEH to the wall, as shown in Figure 3-6. Tighten the four anchor screws.

3.2.5Free-Standing Installation

For a free-standing shelf or tabletop installation, locate the SEH within 7 feet of its power source and with an unrestricted free surface area 21 inches wide, 18 inches deep and 6 inches high, as shown in Figure 3-7.

18 IN.

HubSTACK 10BASE-T HUB WITH LANVIEW®

SEH-24

6 IN.

21 IN.

7 FT.

Figure 3-7. Shelf or Table-top Installation

Page 3-7