%•F"›amV˜"m˜'h¤d"›F=˜/"2 | ˜˜,6˜3¦F•˜":1˜"m=˜/"2' |
1.Enter the start LECS command to activate LANE server services on this switch.
SmartCell ZX # start lecs
NOTICE - 'LECS' ***** LECS started *****
SmartCell ZX #
2.Create an ELAN on your SmartCell 6A000 switch by executing the add elan command. The following is an example.
SmartCell ZX # add elan |
|
ELANNumber(0) : 1 | <1 is used instead of the default, (0) |
ELANName(ELAN001): Marketing <ELAN is named Marketing instead of the default, (ELAN000)
ConnectMethod(SVC): |
|
ELANType(802.3) | <The default (Ethernet) is used |
Multipoint(YES) : |
|
MTU(1516) : |
|
Distribute(PROXY) : |
|
SmartCell ZX # |
|
3.Create a client for the switch on the ELAN. For example, enter
SmartCell ZX # add laneclient
ClientNumber(0) :1<One is used instead of the default, (0)
LanName(ELAN001) : Marketing < ELAN name is Marketing, not the default, (ELAN001)
ServerType(LECS) : |
|
ServerAddress() | <No LANE server address is specified; see note below |
IPAddress() : 90.1.1.1 | < IP address and subnet mask are included only as examples |
NetMask(255.0.0.0): 255.255.255.0
MTU(1516) :
SmartCell ZX #
Note The command add laneclient always prompts you with a subnet mask that is appropriate for the IP address. However, if necessary, you can change the subnet mask to correspond to the strategy employed within your networks.
Note When you create a client, it automatically finds the LECS address using ILMI.
As the local client joins the ELAN, the following messages are sent to the Event log:
NOTICE - 'ZLESSRV' LES Join 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
NOTICE - 'ZLESSRV' BUS Connect 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
Caution Never create an ELAN (or ELAN client) with the same subnet as the SmartCell 6A000 Ethernet port.