SmartCell ZX # show portconfig a1

Switch Installation and Setup

Using the Console

start: Start a process on the switch; for example, start the LAN Emulation Configuration Server.

restart: Restart a process on the switch; for example, restart a client.

flush: Remove assigned values; for example, flush a route table.

alias: Create easier names for often-used commands and their parameters.

Entering parameters at the command line is optional. If a command requires parameter values, it prompts you for them. For instance, in the example below, show is the operator, portconfig is the switch-attribute, and a1 is the parameter indicating that you want to show configuration information about port A1.

==================================================

Port: A1

--------------------------------------------------

Parameter		Configured	Current
--------------------------------------------------
Sig	Type	autoConfig	pnni10
Sig	Role	other	symmetric
Interface Type		private	private
Max	vpi bits	0	0
Max	vci bits	12	12
Max	SVC vpci	0	0
Min	SVC vci	32	32
Max	Vccs	4096	4096
--------------------------------------------------
Other parameters
--------------------------------------------------
Port Admin Status		UP
Ilmi	Admin Status	Enabled AddressRegistration Connectivity
Oper State		UP
Trans Type		STS-3c
Media Type		MMF (S)
Bandwidth		155 MB
SmartCell ZX #

If you don’t specify parameters with the command, the console prompts you for an input value and provides a default value displayed in parenthesis. For example, if you enter show portconfig without specifying a port (as a parameter), the following appears. Here, the default of “ all” ports is presented. You can either accept the default by pressing Enter, or you can enter a specific port number. Taking the default displays the following:

SmartCell ZX # show portconfig
PortNumber(ALL)				:
Port	Intf	Sig	Trans	Media	Speed	Oper
ID	Type	Type	Type	Type	(MB/s)	State

==============================================================================

A1	private	pnni10	STS-3c	MMF (S)	155	MB	UP
A2	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
A3	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
A4	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
B1	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
B2	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
B3	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
B4(CPU)	private	uni31	STS-3c	MMF (S)	155	MB	UP
C1	private	autoConfig	STS-3c	SMF (I)	155	MB	DOWN
C2	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
C3	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
C4	private	autoConfig	STS-3c	MMF (S)	155	MB	DOWN
D1	private	autoConfig	STS-3c	CAT5 UTP	155	MB	DOWN
D2	private	autoConfig	STS-3c	CAT5 UTP	155	MB	DOWN
D3	private	autoConfig	STS-3c	CAT5 UTP	155	MB	DOWN
D4	private	autoConfig	STS-3c	CAT5 UTP	155	MB	DOWN

SmartCell ZX #

SmartCell 6A000 User Guide 2-9