Cabletron Systems manual Installing the BRIM-T6

Page 17

INSTALLATION

Standoff screw

T6

BRIM

XMT 16Mb

RCV

STB

Connector pins under BRIM

Connector

Coverplate screw

Figure 2-2. Installing the BRIM-T6

5.Insert the connector pins on the underside of the BRIM into the motherboard connector on the MIM by pressing down ﬁrmly on the rear section of the BRIM until the pins slide all the way into the connector holes.

6.Fasten the BRIM securely to the MIM motherboard with the coverplate and standoff screws.

See Section 2.4 for TPIM conﬁguration and installation instructions.

2-3

Image 17

Contents BRIM-T6 USER’S Guide Page All Rights Reserved Order Number 9031288 September Vcci Notice FCC NoticeDOC Notice Cabletron Software Program License Program License AgreementUnited States Government Restricted Rights Exclusion of Warranty & Disclaimer LiabilityContents Appendix B Media Specifications and Requirements Chapter Introduction Using this ManualMedia Flexibility Introducing the BRIM-T6Bridge/Routing Protocols Jumper Selectable Ring SpeedSpanning Tree Algorithm STA Compliance BRIM-T6 ManagementSafety Brim SpecificationsRelated Documentation EnvironmentNetworking Publications Getting HelpIntroduction Unpacking the BRIM-T6 Chapter InstallationInstalling the BRIM-T6 Installing the BRIM-T6 into a MIM Installing the BRIM-T6 Configuring the BRIM-T6 Ring Speed Installing the BRIM-T6 into a Standalone DeviceSPD Configuring and Installing TPIMs Tpim Conﬁguration for Station Applications Installing TPIMs Connecting STP Segments Chapter Connecting to the NetworkConnecting Fiber Optic Segments Connecting UTP SegmentsConnecting Fiber Optic Segments Connecting to the Network 16Mb Ring Speed Chapter Monitoring and TroubleshootingLanview Leds RCV Receive XMT TransmitSTB Standby LNK Media Link OK on attached TpimLED Speciﬁcations Summary Checking the ConnectionMonitoring and Troubleshooting Fiber Optic Tpim Specifications Appendix a Tpim SpecificationsTwisted Pair Tpim Pinouts Station Mode Tpim Specifications Fiber Optic Appendix B Media Specifications and RequirementsImpedance and Attentuation Shielded Twisted Pair STPMaximum Trunk Lengths Unshielded Twisted Pair UTPMaximum Lobe Length Table B-4. UTP Voice Grade and Category 3 Speciﬁcations Attenuation and ImpedanceMaximum Lobe Lengths Media Specifications and Requirements