Cabletron Systems BRIM-T6 manual Installing TPIMs

INSTALLATION

2.4.2 Installing TPIMs

To install a TPIM into the BRIM-T6, refer to Figure 2-5 and follow these steps:

1.Slide the TPIM into the TPIM slots until the connector pins in the BRIM are fully inserted into the connector on the TPIM.

2.Fasten the mounting screw to secure the TPIM in place.

TPIM

Slot

BRIM T6

16Mb XMT

STB RCV

STACK2 STACK3 STACK4 STACK5

Connector

Mounting Screw

Figure 2-5. Installing a TPIM

The BRIM-T6 is now ready for operation. The next chapter describes procedures for connecting a properly configured and installed BRIM-T6 to the network.

2-8