Configuring the BRIM-T6 Ring Speed | Cabletron Systems specs

INSTALLATION

2.2.2 Installing the BRIM-T6 into a Standalone Device

Standalone devices have the same physical setup for BRIM installation as MIMs. So you can refer to Figure 2-1 and Figure 2-2 when installing a BRIM-T6 into a standalone device.

To install a BRIM into a standalone device:

1.Power off the device and remove its chassis cover. Refer to the documentation included with the host device for instructions on removing the chassis cover.

2.Remove the BRIM receptacle coverplate and the standoff screws from the standoffs as shown in Figure 2-1.

3.Place the BRIM behind the receptacle panel, aligning the screw holes on the BRIM with their corresponding screw holes on the BRIM receptacle panel and on the standoffs as shown in Figure 2-2.

4.Insert the connector pins on the underside of the BRIM into the motherboard connector in the device. Press down ﬁrmly on the rear section of the BRIM until the pins slide all the way into the connector holes.

5.Fasten the BRIM securely to the device motherboard with the coverplate and standoff screws.

6.Reinstall the device chassis cover and then power on the device.

2.3 CONFIGURING THE BRIM-T6 RING SPEED

You must conﬁgure the BRIM-T6 ring speed to match the ring speed of the Token Ring to which it is physically linked. The BRIM-T6 ring speed setting does not, however, have to match the ring speed setting of its host device.

Also, you must reset the host device containing the BRIM-T6 after you change the BRIM-T6’s ring speed for the change to take effect.

2-4