Cabletron Systems BRIM-T6 manual Exclusion of Warranty & Disclaimer Liability

Page 6

NOTICE

EXCLUSION OF WARRANTY & DISCLAIMER OF

LIABILITY

1.EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including Its documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABLITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

2.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL CABLETRON OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS CABLETRON PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR ON THE DURATION OR LIMITATION OF IMPLIED WARRANTEES IN SOME INSTANCES THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU.

UNITED STATES GOVERNMENT RESTRICTED

RIGHTS

The enclosed product (a) was developed solely at private expense; (b) contains “restricted computer software” submitted with restricted rights in accordance with Section 52227-19

(a)through (d) of the Commercial Computer Software - Restricted Rights Clause and its successors, and (c) in all respects is proprietary data belonging to Cabletron and/or its suppliers.

For Department of Defense units, the product is licensed with “Restricted Rights” as defined in the DoD Supplement to the Federal Acquisition Regulations, Section

52.227-7013 (c) (1) (ii) and its successors, and use, duplication, disclosure by the Government is subject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at 252.227-7013. Cabletron Systems, Inc., 35 Industrial Way, Rochester, New Hampshire 03867

iv

Image 6
Contents BRIM-T6 USER’S Guide Page All Rights Reserved Order Number 9031288 September FCC Notice DOC NoticeVcci Notice Program License Agreement Cabletron Software Program LicenseExclusion of Warranty & Disclaimer Liability United States Government Restricted RightsContents Appendix B Media Specifications and Requirements Using this Manual Chapter IntroductionIntroducing the BRIM-T6 Media FlexibilitySpanning Tree Algorithm STA Compliance Jumper Selectable Ring SpeedBridge/Routing Protocols BRIM-T6 ManagementRelated Documentation Brim SpecificationsSafety EnvironmentGetting Help Networking PublicationsIntroduction Chapter Installation Installing the BRIM-T6Unpacking the BRIM-T6 Installing the BRIM-T6 into a MIM Installing the BRIM-T6 Installing the BRIM-T6 into a Standalone Device Configuring the BRIM-T6 Ring SpeedSPD Configuring and Installing TPIMs Tpim Configuration for Station Applications Installing TPIMs Chapter Connecting to the Network Connecting STP SegmentsConnecting UTP Segments Connecting Fiber Optic SegmentsConnecting Fiber Optic Segments Connecting to the Network Chapter Monitoring and Troubleshooting Lanview Leds16Mb Ring Speed STB Standby XMT TransmitRCV Receive LNK Media Link OK on attached TpimChecking the Connection LED Specifications SummaryMonitoring and Troubleshooting Appendix a Tpim Specifications Twisted Pair Tpim Pinouts Station ModeFiber Optic Tpim Specifications Tpim Specifications Appendix B Media Specifications and Requirements Fiber OpticShielded Twisted Pair STP Impedance and AttentuationUnshielded Twisted Pair UTP Maximum Lobe LengthMaximum Trunk Lengths Attenuation and Impedance Table B-4. UTP Voice Grade and Category 3 SpecificationsMaximum Lobe Lengths Media Specifications and Requirements