Cabletron Systems BRIM-T6 manual FCC Notice, DOC Notice, Vcci Notice

Page 4

NOTICE

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

ii

Image 4
Contents BRIM-T6 USER’S Guide Page All Rights Reserved Order Number 9031288 September DOC Notice FCC NoticeVcci Notice Program License Agreement Cabletron Software Program LicenseExclusion of Warranty & Disclaimer Liability United States Government Restricted RightsContents Appendix B Media Specifications and Requirements Using this Manual Chapter IntroductionIntroducing the BRIM-T6 Media FlexibilityJumper Selectable Ring Speed Bridge/Routing ProtocolsSpanning Tree Algorithm STA Compliance BRIM-T6 ManagementBrim Specifications SafetyRelated Documentation EnvironmentGetting Help Networking PublicationsIntroduction Installing the BRIM-T6 Chapter InstallationUnpacking the BRIM-T6 Installing the BRIM-T6 into a MIM Installing the BRIM-T6 Installing the BRIM-T6 into a Standalone Device Configuring the BRIM-T6 Ring SpeedSPD Configuring and Installing TPIMs Tpim Configuration for Station Applications Installing TPIMs Chapter Connecting to the Network Connecting STP SegmentsConnecting UTP Segments Connecting Fiber Optic SegmentsConnecting Fiber Optic Segments Connecting to the Network Lanview Leds Chapter Monitoring and Troubleshooting16Mb Ring Speed XMT Transmit RCV ReceiveSTB Standby LNK Media Link OK on attached TpimChecking the Connection LED Specifications SummaryMonitoring and Troubleshooting Twisted Pair Tpim Pinouts Station Mode Appendix a Tpim SpecificationsFiber Optic Tpim Specifications Tpim Specifications Appendix B Media Specifications and Requirements Fiber OpticShielded Twisted Pair STP Impedance and AttentuationMaximum Lobe Length Unshielded Twisted Pair UTPMaximum Trunk Lengths Attenuation and Impedance Table B-4. UTP Voice Grade and Category 3 SpecificationsMaximum Lobe Lengths Media Specifications and Requirements