Cabletron Systems BRIM-T6 manual Checking the Connection, LED Specifications Summary

MONITORING AND TROUBLESHOOTING

Table 4-1. LED Specifications Summary

LED	Status	Description
16Mb (Ring Speed)	Solid Yellow	16 Mbps
	Off	4 Mbps
XMT (Transmit)	Flashing Green	Transmitting Traffic
	Solid Red	Disabled
	Blinking Red	Speed Fault Error
RCV (Receive)	Solid Green	Enabled
	Flashing Yellow	Receiving Traffic
	Solid Red	Disabled
STB (Standby)	Solid Yellow	Standby
LNK (Link)	Solid Green	Media Link OK

4.2 CHECKING THE CONNECTION

This section provides a checklist for troubleshooting network connection problems.

The LNK LED on the TPIM lights green when there is an established link between the BRIM-T6 and the device at the other end of the media connection. If, however, the LNK LED lights red or is not lighted, a link has not been established. To resolve the problem, try the following procedures:

•Check that the host device and the device at the other end of the segment have power.

•Check that the TPIM is securely installed in the BRIM-T6 and that the BRIM-T6 is securely installed in the host device.

•Check for correct connector-to-port attachments at the BRIM-T6 and the destination device.

•Inspect the cabling system (cable and connectors) for damage and replace damaged components.

4-3