Cabletron Systems BRIM-T6 manual Spd

INSTALLATION

The BRIM-T6 default ring speed setting is 16 Mbps. The other available setting is 4 Mbps. To configure the ring speed, refer to the settings illustrated in Figure 2-3 and follow these steps:

1.Remove the MIM from the MMAC; if the BRIM-T6 is installed in a standalone device, remove the chassis cover from the device to provide access to the BRIM-T6’s component board surface.

2.Slide the jumper down over pins 2 and 3 to select a 16 Mbps setting or over pins 1 and 2 to select a 4 Mbps setting.

3.Reset the device containing the BRIM-T6.

Ring Speed Jumper Settings

	J3
1	2	3
4 M	SPD	16M

	J3
1	2	3
4 M	SPD	16M

4 Mbps Setting 16 Mbps Setting

	J3	Front Panel
4 M	16M SPD

Figure 2-3. BRIM-T6 Ring Speed Settings

2-5