Cabletron Systems 1200, 1000 manual Device Name? Monterey Device Table Menu Device = Monterey

IP ROUTING NETWORK WITH REMOTE BRIDGE DEVICES

Configure the CyberSWITCH

CONFIGURING THE SECURITY LEVEL

To begin, press 1 at the Security Menu, and the Security Level Menu will be displayed. To enable Device Level Security, press 2.

CONFIGURING THE SYSTEM OPTIONS AND INFORMATION

The default configuration for System Options is all security options enabled, which is acceptable for this network. No System Information or Administration Sessions are required. Therefore, no changes are necessary.

CONFIGURING THE DEVICE LEVEL DATABASES

Press 3 at the Security Menu, and the Device Level Database Menu will be displayed. To enable the On-node Device Database, press 1 and follow the on-screen instructions.

To add the remote devices, press 2 (On-node Device entries). Press 1 to configure the information for our first device, Monterey. You will be prompted for the device name, followed by the Device Table Menu:

Device Name? Monterey

Device Table Menu: (Device = "Monterey")

1)ISDN

2)Frame Relay

3)X.25

4)Authentication

5)IP

6)IPX

7)AppleTalk

8)Bridging

9)Compression

Select function from above or <RET> for previous menu: 1

Select 1, ISDN. The ISDN Menu will display the preconfigured default values:

Device ISDN Menu: (Device = "Monterey")

1)	ISDN Line Protocol		“PPP (Point to Point Protocol)”
2)	Base Data Rate		“64000 bps”
3)	Initial	Data Rate	“64000 bps”
4)	Maximum	Data Rate	“128000 bps”
5)	Dial Out Phone Number(s)		“”
6)	Subaddress		“”
7)	Profile	Name	“Default_Profile”
8)	H0 Call	Support	DISABLED

Select function from above or <RET> for previous menu: 1

We do not want to use the default ISDN Line Protocol of PPP. Press 1 to configure this device’s ISDN line protocol. The device Monterey uses HDLC protocol, so we will press 2:

Workgroup Remote Access Switch 55