IP ROUTING NETWORK WITH PPP DEVICES
Verify the Installation
CONFIGURING STATIC ROUTES
To configure the static route information for SITE2, refer to the instructions provided for SITE1 (page 71) with the following exceptions:
Static Route for SITE2:
•Enter Y when asked if this static route is a default route.
•Enter SITE1 for the Next Hop name.
CONFIGURING SECURITY
CONFIGURING SYSTEM OPTIONS AND INFORMATION
Follow the instructions used for configuring the system information for SITE1 (page 74) with the following system information exceptions:
•System Name: SITE2
•System Secret: ikcd98s
SAVE CONFIGURATION FILES
We have now configured all the required information for SITE2. Return to the Main Menu, save your configuration files, and exit. Restart the SITE2 to activate the changes.
VERIFY THE INSTALLATION
Steps on how to verify the installation are detailed in the System Verification chapter of the User’s Guide. This section gives an outline of which steps should be executed for Example 1.
On each system:
Verify resources are operational
Issue dr command
Look for WAN board initialized messages
Look for BRI line messages
Look for LAN initialization messages
Look for Bridge initialization messages
Verify WAN Lines Available
Connect WAN lines
Issue dr command
Look for “Data Link up 1,1” in reports
On SITE1:
Check connectivity to local devices
IP PING 128.1.1.8 (host)
IP PING 128.1.1.3 (server)
IP PING 128.1.1.7 (router)
Check connectivity to SITE2
CALL DEVICE SITE2
Check connectivity to remote devices
IP PING 128.3.3.1 (SITE2)
IP PING 128.3.3.4 (host)
Workgroup Remote Access Switch 75