EMC DS-16B2 manual Configuring the IP Address

Page 15

Setting the Initial Switch Configuration

Configuring the IP Address

The Departmental Switch DS-16B2 switch is shipped with a default

IP address of 10.77.77.77.

To change the default IP Address and configure the Fibre Channel IP address of the switch:

1.Login to the switch as the admin user.

2.At the command line, enter the following command: ipAddrSet

3.An interactive session opens and prompts you for configuration values.

a.Press ENTER without entering a value to skip over a prompt and leave the parameter value as the default.

b.At the Ethernet IP Address prompt, enter the new IP address for the Ethernet port on the switch. Press ENTER to continue.

c.At the Ethernet Subnetmask prompt, enter the address of the subnetmask, if applicable. Press ENTER to continue.

d.At the Gateway Address prompt, enter the IP address of the gateway system if applicable. Press ENTER to continue.

e.The configuration is then committed to the switch firmware.

f.You are then prompted whether to make the IP address changes active now or at the next reboot. Enter y at the prompt to have the IP address changes take effect immediately.

Configuring the IP Address	1-5

1

Image 15

Contents Procedures Manual Departmental Switch Model DS-16B2 Fabric OSCopyright 2001 EMC Corporation. All rights reserved Trademark Information Departmental Switch DS-16B2 Fabric OS Procedures Manual Contents Chapter Displaying Error Logs and Status Preface Damage to the system or equipment. The caution may apply to Palatino Http//powerlink.emc.com Setting the Initial Switch Configuration Switch55admin Logging In to a SwitchEnabling Licensed Features Changing the Admin Password and User ID Displaying the Installed Feature LicensesConfiguring the IP Address Displaying the Fabric-Wide Device Count Basic Switch Configuration Procedures Displaying the Firmware Version Setting the Telnet Timeout ValueSetting the Switch Date and Time Backing Up the System Configuration Settings Displaying the System Configuration SettingsRestoring the System Configuration Settings Disabling a Switch Upgrading or Restoring the Switch FirmwareEnabling a Switch Disabling a PortEnabling a Port Changing a Switch Name Viewing the Policy Threshold Values Setting the Switch Status PolicyDisplaying Whether Track Changes is Enabled Enabling the Track Changes FeatureDisplaying Help Information for a Telnet Command Configuring a Static Route Between Two PortsExample Reading Hexadecimal Port Diagrams0000 0001 0010 1000 0011 Departmental Switch DS-16B2 Fabric OS Procedures Manual Displaying Error Logs Status Statistics for a Port Displaying the Status of a PortError Type Description Displaying a Summary of Port ErrorsDisplaying the Switch Status Displaying the Error Log of a SwitchDisplaying Information About a Switch Displaying the Fan Status Displaying the Uptime of the SwitchDisplaying Power Supply Status Displaying the Temperature Status Running Diagnostic Tests on the Switch HardwareSupportShow Syntax supportShow firstPort, lastPort, nLog Displaying Error Logs and Status Customer Support Figure A-1Problem Detection and Resolution Process Overview of Detecting and Resolving ProblemsTroubleshooting the Problem Before Calling the Customer Support Center Documenting the Problem Reporting a New Problem FTP Sending Problem DocumentationCustomer Support Glossary Glossary Glossary Configuration EIA Rack Glossary Glossary Glossary See also Nonparticipating Mode and Participating Mode Glossary Glossary Glossary Glossary Glossary UDP Glossary