EMC DS-16B2 manual Upgrading or Restoring the Switch Firmware, Disabling a Switch

Page 22

2

Basic Switch Configuration Procedures

Upgrading or Restoring the Switch Firmware

To upgrade or restore the switch firmware:

1.Verify that the RSHD service/utilities or the FTP service is running on the host workstation.

2.Log in to the switch as the admin user.

3.At the command line, enter the following command: firmwareDownload

4.Press ENTER.

The system prompts you to enter the Host IP address, User Name, Filename, and password.

The password operand is only required if you are using FTP.

5.Reboot the switch by entering the following command: fastBoot

Disabling a Switch

To disable a switch:

1.Log in to the switch as the admin user.

2.At the command line, enter the following command: switchDisable

All Fibre Channel ports on the switch are taken offline. If the switch was part of a fabric, the remaining switches reconfigure.

2-6	Departmental Switch DS-16B2 Fabric OS Procedures Manual

Image 22

Contents Departmental Switch Model DS-16B2 Fabric OS Procedures ManualCopyright 2001 EMC Corporation. All rights reserved Trademark Information Departmental Switch DS-16B2 Fabric OS Procedures Manual Contents Chapter Displaying Error Logs and Status Preface Damage to the system or equipment. The caution may apply to Palatino Http//powerlink.emc.com Setting the Initial Switch Configuration Logging In to a Switch Switch55adminEnabling Licensed Features Displaying the Installed Feature Licenses Changing the Admin Password and User IDConfiguring the IP Address Displaying the Fabric-Wide Device Count Basic Switch Configuration Procedures Setting the Telnet Timeout Value Displaying the Firmware VersionSetting the Switch Date and Time Displaying the System Configuration Settings Backing Up the System Configuration SettingsRestoring the System Configuration Settings Upgrading or Restoring the Switch Firmware Disabling a SwitchDisabling a Port Enabling a SwitchEnabling a Port Changing a Switch Name Setting the Switch Status Policy Viewing the Policy Threshold ValuesEnabling the Track Changes Feature Displaying Whether Track Changes is EnabledConfiguring a Static Route Between Two Ports Displaying Help Information for a Telnet CommandReading Hexadecimal Port Diagrams Example0000 0001 0010 1000 0011 Departmental Switch DS-16B2 Fabric OS Procedures Manual Displaying Error Logs Status Displaying the Status of a Port Statistics for a PortDisplaying a Summary of Port Errors Error Type DescriptionDisplaying the Error Log of a Switch Displaying the Switch StatusDisplaying Information About a Switch Displaying the Uptime of the Switch Displaying the Fan StatusDisplaying Power Supply Status Running Diagnostic Tests on the Switch Hardware Displaying the Temperature StatusSupportShow Syntax supportShow firstPort, lastPort, nLog Displaying Error Logs and Status Customer Support Overview of Detecting and Resolving Problems Figure A-1Problem Detection and Resolution ProcessTroubleshooting the Problem Before Calling the Customer Support Center Documenting the Problem Reporting a New Problem Sending Problem Documentation FTPCustomer Support Glossary Glossary Glossary Configuration EIA Rack Glossary Glossary Glossary See also Nonparticipating Mode and Participating Mode Glossary Glossary Glossary Glossary Glossary UDP Glossary