EMC DS-16B2 manual Enabling the Track Changes Feature, Displaying Whether Track Changes is Enabled

Page 26

2

Basic Switch Configuration Procedures

Enabling the Track Changes Feature

Displaying Whether Track Changes is Enabled

To enable the track changes feature:

1.Log in to the switch as the admin user.

2.At the command line, enter the following command: trackChangesSet 1

A prompt is displayed verifying that the track changes feature is on. The output from the track changes feature is dumped to the error log for the switch. Use the errdump command or errshow command to view the error log.

Trackable changes are:

•Successful login

•Unsuccessful login

•Logout

•Config file change from task

•Track changes on

•Track changes off

Items in the error log created from the Track changes feature are labeled Error TRACK. For example:

Error 08

--------

0x102cf710 (tShell): May 2 16:12:10 Error TRACK-LOGIN, 4, Successful login

To display the status of the track changes feature:

1.Log in to the switch as the admin user.

2.At the command line, enter the following command: trackChangesShow

The status of the track changes feature is displayed as either on or off. This also displays whether the track changes feature is configured to send SNMP traps. For example:

switch:admin> trackchangesshow Track changes status: ON

Track changes generate SNMP-TRAP: NO

2-10	Departmental Switch DS-16B2 Fabric OS Procedures Manual

Image 26

Contents Departmental Switch Model DS-16B2 Fabric OS Procedures ManualCopyright 2001 EMC Corporation. All rights reserved Trademark Information Departmental Switch DS-16B2 Fabric OS Procedures Manual Contents Chapter Displaying Error Logs and Status Preface Damage to the system or equipment. The caution may apply to Palatino Http//powerlink.emc.com Setting the Initial Switch Configuration Logging In to a Switch Switch55adminEnabling Licensed Features Displaying the Installed Feature Licenses Changing the Admin Password and User IDConfiguring the IP Address Displaying the Fabric-Wide Device Count Basic Switch Configuration Procedures Setting the Telnet Timeout Value Displaying the Firmware VersionSetting the Switch Date and Time Displaying the System Configuration Settings Backing Up the System Configuration SettingsRestoring the System Configuration Settings Upgrading or Restoring the Switch Firmware Disabling a SwitchEnabling a Port Enabling a SwitchDisabling a Port Changing a Switch Name Setting the Switch Status Policy Viewing the Policy Threshold ValuesEnabling the Track Changes Feature Displaying Whether Track Changes is EnabledConfiguring a Static Route Between Two Ports Displaying Help Information for a Telnet CommandReading Hexadecimal Port Diagrams Example0000 0001 0010 1000 0011 Departmental Switch DS-16B2 Fabric OS Procedures Manual Displaying Error Logs Status Displaying the Status of a Port Statistics for a PortDisplaying a Summary of Port Errors Error Type DescriptionDisplaying the Error Log of a Switch Displaying the Switch StatusDisplaying Information About a Switch Displaying the Uptime of the Switch Displaying the Fan StatusDisplaying Power Supply Status SupportShow Displaying the Temperature StatusRunning Diagnostic Tests on the Switch Hardware Syntax supportShow firstPort, lastPort, nLog Displaying Error Logs and Status Customer Support Overview of Detecting and Resolving Problems Figure A-1Problem Detection and Resolution ProcessTroubleshooting the Problem Before Calling the Customer Support Center Documenting the Problem Reporting a New Problem Sending Problem Documentation FTPCustomer Support Glossary Glossary Glossary Configuration EIA Rack Glossary Glossary Glossary See also Nonparticipating Mode and Participating Mode Glossary Glossary Glossary Glossary Glossary UDP Glossary