EMC DS-16B2 manual Displaying Error Logs and Status

Page 40

3

Displaying Error Logs and Status

Operands This command has the following operands:

firstPort Specify the first port, of a range of ports, to dump information. The default (if no operand specified) is to print state of port 0. If only firstPort is specified, only information for firstPort is printed.

lastPort Specify the last port, of range of ports, to dump information.

nLog Specify the number of lines of portLogDump to print:

0 = dump all lines (default)

N = dump the last N lines

<0 = skip portLogDump

Example If firstPort is specified but lastPort is not specified, only firstPort information is printed for the port-based commands (portShow, portRegShow, portRouteShow). If no operand is supplied, firstPort is set to 0 and lastPort is set to maximum port of switch.

sw7:admin> supportShow Kernel: 5.3.1

Fabric OS: v2.1

Made on: Tue Apr 6 16:57:22 PDT 1999

Flash: Thu Apr 1 10:23:43 PST 1999

BootProm: Thu Oct 1 13:34:29 PDT 1998

37 34 37 45 49 Centigrade

3-10	Departmental Switch Model DS-16B2 Fabric OS Procedures Manual

Image 40

Contents Departmental Switch Model DS-16B2 Fabric OS Procedures ManualCopyright 2001 EMC Corporation. All rights reserved Trademark Information Departmental Switch DS-16B2 Fabric OS Procedures Manual Contents Chapter Displaying Error Logs and Status Preface Damage to the system or equipment. The caution may apply to Palatino Http//powerlink.emc.com Setting the Initial Switch Configuration Logging In to a Switch Switch55adminEnabling Licensed Features Displaying the Installed Feature Licenses Changing the Admin Password and User IDConfiguring the IP Address Displaying the Fabric-Wide Device Count Basic Switch Configuration Procedures Setting the Telnet Timeout Value Displaying the Firmware VersionSetting the Switch Date and Time Displaying the System Configuration Settings Backing Up the System Configuration SettingsRestoring the System Configuration Settings Upgrading or Restoring the Switch Firmware Disabling a SwitchDisabling a Port Enabling a SwitchEnabling a Port Changing a Switch Name Setting the Switch Status Policy Viewing the Policy Threshold ValuesEnabling the Track Changes Feature Displaying Whether Track Changes is EnabledConfiguring a Static Route Between Two Ports Displaying Help Information for a Telnet CommandReading Hexadecimal Port Diagrams Example0000 0001 0010 1000 0011 Departmental Switch DS-16B2 Fabric OS Procedures Manual Displaying Error Logs Status Displaying the Status of a Port Statistics for a PortDisplaying a Summary of Port Errors Error Type DescriptionDisplaying the Error Log of a Switch Displaying the Switch StatusDisplaying Information About a Switch Displaying the Uptime of the Switch Displaying the Fan Status Displaying Power Supply Status Running Diagnostic Tests on the Switch Hardware Displaying the Temperature StatusSupportShow Syntax supportShow firstPort, lastPort, nLog Displaying Error Logs and Status Customer Support Overview of Detecting and Resolving Problems Figure A-1Problem Detection and Resolution ProcessTroubleshooting the Problem Before Calling the Customer Support Center Documenting the Problem Reporting a New Problem Sending Problem Documentation FTPCustomer Support Glossary Glossary Glossary Configuration EIA Rack Glossary Glossary Glossary See also Nonparticipating Mode and Participating Mode Glossary Glossary Glossary Glossary Glossary UDP Glossary