Extron electronic IPL T S Series manual Furniture or projector mounting

Installation and Operation, cont’d

IPLTS2

R

1TX 2

COM
RX	RTS	CTS

®

100 LINK ACT

IPLTS2

R

1TX 2

COM
RX	RTS	CTS

®

100 LINK ACT

MDA

DISTRIBUTIONSERIES

AMPLIFIER

Figure 2-2 — Mounting the interface on the standard shelf

Furniture or projector mounting

The following furniture and projector mount kits are available:

•	PN 70-077-01	Furniture mount kit (for IPL T S1)
•	PN 70-077-04	Projector mount kit (for IPL T S1)
•	PN 70-212-01	Furniture mount kit (for IPL T S2, S4, S6)
•	PN 70-217-04	Projector mount kit (for IPL T S2, S4, S6)
To mount an IPL T S Series device to furniture:
1.	If present, remove the rubber feet from the bottom of the IPL T S unit.
2.	Attach the furniture mounting brackets to the unit with the supplied screws.
3.	Hold the unit with the attached brackets against the underside of the
	furniture. Mark the hole locations of the bracket on the mounting surface.

4.Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the underside of the mounting surface at the marked hole locations.

5.	Insert #8 wood screws into the four pilot holes. Tighten each screw until just
	less than 1/4” (6.3 mm) of the screw head protrudes above the surface.
6.	Hang the mounting bracket over the protruding screw heads. Slide the
	mounting brackets to the narrow end of the screw slots and tighten the
	mounting screws.
To mount an IPL T S Series device with a projector:
1.	If present, remove the rubber feet from the bottom of the IPL T S unit.
2.	Attach the projector mounting bracket to the unit with the supplied screws.
3.	Secure the unit to the projector post with the supplied mounting bolt.

2-4 IPL T S Series • Installation and Operation