Extron electronic IPL T S Series manual Remap port designations

IPL T S Series • Communication and Control 4-15

Command	ASCII (Telnet)	URL Encoded (Web)	Response	Additional description
	(host to unit)	(host to unit)	(unit to host)

Remap port designations

For security reasons the network administrator may wish to assign new/different port numbers to the controller’s Telnet, Web browser, and direct access ports or to disable one or more ports. Typically Telnet uses port 23, Web access is via port 80 (HTTP), and direct access is via port 2001.

CDo not set two or more ports to the same port number. Setting two ports to the same number could cause networking conflicts and will also result in an E13 (invalid parameter) error.

NIf you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the port by setting it to 0.

Set Telnet port map24	E{port#}MT }	W{port#}MT	Pmt{port#}]	Select a number for the port that will not
				conflict with any other ports.
Reset Telnet port	E23MT}	W23MT	Pmt00023 ]	This resets the Telnet port to port 23.
map24
Disable Telnet port24	E0MT}	W0MT	Pmt00000 ]	Setting the port number to 0 disables the
				port.
View Telnet port map	EMT}	WMT	{port#}]
Set Web port map24	E{port#}MH}	W{port#MH	Pmh{port#}]
Reset Web port map24	E80MH}	W80MH	Pmh00080]	This resets the Web port to port 80.
Disable Web port24	E0MH}	W0MH	Pmh00000]
View Web port map24	EMH}	WMH	{port#}]
Set Direct Access port	E{port#}MD}	W{port#}MD	Pmd{port#}]
map24
Reset Direct Access	E2001MD}	W2001MD	Pmd02001]	This resets the direct access port to port
port map24				2001.
Disable Direct Access	E0MD}	W0MD	Pmd00000]
port24
View Direct Access	EMD}	WMD	{port#}]
port map

NDuplicate port# assignments are not permitted (i.e., Telnet and Web cannot be the same) and result in an E13 (invalid parameter) response.