Note: See Chapter 7, “Parts listing, BladeCenter Type 8677 and 1881,” on page 79 to determine which components should be replaced by a field service technician.
Message | Action |
|
|
Switch module%d IP configuration was | Information only. Take action as required. |
changed |
|
|
|
ENET [X] DHCP HSTN=X, DN=X, IP @= | Ethernet configuration information. Take action as required. |
XXX.XXX.XXX.XXXGW @= |
|
XXXX.XXX.XXX.XXX, SN= |
|
XXX,XXX,XXX,XXX, DNS1@= |
|
XXX.XXX.XXX.XXX |
|
|
|
ENET [X] IP Cfg:HstName= XXXX, IP@= | Ethernet configuration information. Take action as required. |
XXX.XXX.XXX.XXX ,GW@= |
|
XXX.XXX.XXX.XXX, NetMsk= |
|
XXX.XXX.XXX.XXX Switch module x was |
|
installed |
|
|
|
LAN: Ethernet [x] interface is no longer | Check cables to I/O module. |
active |
|
|
|
LAN: Ethernet [x] interface now longer | Information only. Take action as required. |
active |
|
|
|
Management-module error messages
Note: See Chapter 7, “Parts listing, BladeCenter Type 8677 and 1881,” on page 79 to determine which components should be replaced by a field service technician.
Message | Action | ||
|
| ||
Application posted alert to ASM | The alert button on the Web interface was tested. Information only. | ||
| Take action as required. | ||
|
| ||
System log 75% full | Information only. Take action as required. | ||
|
| ||
System log full | Information only. Take action as required. | ||
|
| ||
Management module network | Information only. Take action as required. | ||
initialization complete |
|
| |
|
| ||
Remote login successful. Login ID | Information only. Take action as required. | ||
|
| ||
ASM reset was caused by restoring | The | ||
default values | default settings. Information only. Take action as required. | ||
|
| ||
ASM reset was initiated by the user | Information only. Take action as required. | ||
|
|
| |
Pushbutton reset activated: Ethernet | 1. | Reseat the management module. | |
configuration reset to default values and | |||
2. | Reflash the | ||
MM ASM reset due to watchdog timeout | 3. | Replace the management module. | |
| |||
|
|
| |
ASM reset due to XXXXX, instruction | 1. | Reseat the management module. | |
fault: XXXXXXXX YYYYYYYY ZZZZZZ | |||
2. | Reflash the | ||
| |||
| 3. | Replace the management module. | |
|
| ||
ASM reset reason unknown | Information only. | ||
|
| ||
Possible ASM reset occurred reason | Information only. | ||
unknown |
|
| |
|
| ||
Remote access attempt failed. Invalid | Failed attempt to log into the management module. | ||
userid or password received. User is |
|
| |
XXX from CMD mode client at |
|
| |
IP@=XXX.XXX.XXX.XXX |
|
| |
|
|
| |
Chapter 6.
