
7.Attach any cables or cords required by the module. See “Input/output connectors” on page 46 for the location of connectors on the BladeCenter unit. Be sure to route the power cord on a power module through the
8.Make sure the LEDs on the module indicate that it is operating properly. Verify that:
vThe dc power LED and the ac power LED on each power module are lit and that the power module error LED
vThe OK LED on the management module is lit.
vThe OK LED on each I/O module is lit.
9.If you have other modules to install, do so now; otherwise, go to step 10.
10.Replace the acoustic module option, if you removed it in step 2.
Removing a module
Complete the following steps to remove a power module, management module, or I/O module.
Note: These instructions assume the BladeCenter unit is connected to power.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician.
38BladeCenter E Type 8677 and 1881: Hardware Maintenance Manual and Troubleshooting Guide