Extron electronic IPL T S6, IPL T S4, IPL T S1, IPL T S2 setup guide Hardware Setup, Front Panel

Page 14

Power LED — green when power is on

Reset button — recessed multiple function reset button

TX LED — green when data is being transmitted

RX LED — green when data is being received

RTS LED — green when ready to send data

Hardware Setup

Front Panel

The front panel has a recessed Reset button and the LED indicators described below:

A

B

C

D

E

F CTS LED — green when connected device is ready to receive data

G ACT LED — yellow when port is active

H Link LED — green when connected to a network

I 100 LED — green when connection speed is

100 Mbps. Not lit when connection speed

is 10 Mbps.

IPL T S1

		COM
R	TX	RTS
R
	RX	CTS
		IPL T S1

1

2

3

4

6

5

IPL T S2

IPL T S2

COM

	TX	RX	RTS	CTS	100
R	1				LINK
	2				ACT

1

2

3

4

5

6

7

8

9

IPL T S4

IPL T S4

COM

	TX	RX	RTS	CTS	TX	RX	RTS	CTS	100
R	1				3				LINK
	2				4				ACT

1

2

3

4

5

6

3

4

5

6

7

8

9

IPL T S6

IPL T S6

		COM		CTS		COM
	TX	RX	RTS	CTS	TX	RX	TX	RX	100
R	1				3		5		LINK
	2				4		6		ACT

1

2

3

4

5

6

3

4

3

4

7

8

9

2-2 IPL T S Series Interfaces • Hardware Setup

Image 14

Contents IPL T S Series InterfacesPrecautions Safety Instructions English安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series InterfacesIPL T S Series Products IntroductionAbout this Manual IPL T S1 Introduction, cont’d Global Configurator System requirements Installing Global ConfiguratorClick the Global Configurator icon Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Hardware Setup Front PanelRear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN ConnectionRJ-45 Connector Straight-through Cable Serial Device ConnectionCaptive screw connector Hardware Setup, cont’dPin D connector IPL T S6 Hardware Setup, cont’d Three Step one download device drivers Software SetupCreating a Global Configurator Project File Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Software Setup, cont’d Step two create a new projectIPL T S Series Interfaces Software Setup Click Make this device a GlobalViewer Host if desired Step three add a deviceClick Edit Add Device Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Click Edit Contact Manager Software Setup, cont’d Configuring a New DeviceStep six configure contacts Step seven configure e-mail Click Edit Email ManagerClick Add Driver Driver Configuration tab opensStep eight assign device drivers Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply ConditionApply Email/Contacts Step eleven build the Global Configurator fileBuilding and Uploading a GC File Step twelve upload the Global Configurator file Set Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step thirteen change device settings if desiredClick Tools Change Device Settings Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewerIPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central AmericaSetup Guide Checklist Extron USA East