Extron electronic IPL T S1, IPL T S4, IPL T S6, IPL T S2 setup guide Table of Contents

Page 5

Table of Contents

Chapter One • Introduction

1-1

About this Manual

1-2

IPL T S Series Products

1-2

IPL T S1

1-3

IPL T S2

1-3

IPL T S4

1-3

IPL T S6

1-3

Global Configurator

1-4

System requirements

1-5

Installing Global Configurator

1-5

Chapter Two • Hardware Setup

2-1

Front Panel

2-2

Rear Panel

2-3

Power Connection

2-4

Local Area Network (LAN) Connection

2-4

Serial Device Connection

2-5

9-pin D connector

2-6

Captive screw connector

2-6

Chapter Three • Software Setup

3-1

Creating a Global Configurator Project File

3-2

Step one: download device drivers

3-2

Step two: create a new project

3-4

Step three: add a device

3-6

Step four: define the location of the new device

3-8

Step five: save the new Global Configurator file

3-9

Configuring a New Device

3-10

Step six: configure contacts

3-10

Step seven: configure e-mail

3-11

Step eight: assign device drivers

3-12

Step nine: set scheduled actions and e-mail deliveries

3-13

Step ten: set monitored conditions

3-17

Building and Uploading a GC File

3-19

Step eleven: build the Global Configurator file

3-19

Step twelve: upload the Global Configurator file

3-20

Step thirteen: change device settings (if desired\

3-21

IPL T S Series Interfaces • Table of Contents

i

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Interfaces IPL T S SeriesSafety Instructions English Precautions安全须知 中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces OneIPL T S Series Products IntroductionAbout this Manual IPL T S1 Introduction, cont’d Global Configurator Click the Global Configurator icon Installing Global ConfiguratorSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Front Panel Hardware SetupRear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power ConnectionSerial Device Connection RJ-45 Connector Straight-through CableCaptive screw connector Hardware Setup, cont’dPin D connector IPL T S6 Hardware Setup, cont’d Three Creating a Global Configurator Project File Software SetupStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Step two create a new project Software Setup, cont’dIPL T S Series Interfaces Software Setup Click Make this device a GlobalViewer Host if desired Step three add a deviceClick Edit Add Device Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Click Edit Contact Manager Software Setup, cont’d Configuring a New DeviceStep six configure contacts Click Edit Email Manager Step seven configure e-mailClick Add Driver Driver Configuration tab opensStep eight assign device drivers Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click ConditionsApply Email/Contacts Step eleven build the Global Configurator fileBuilding and Uploading a GC File Step twelve upload the Global Configurator file Set Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step thirteen change device settings if desiredClick Tools Change Device Settings Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer InterfaceIPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s WarrantyExtron USA East Setup Guide Checklist
Top Page Image Contents