Extron electronic IPL T S1 Serial Device Connection, RJ-45 Connector Straight-through Cable

Page 17

Pinouts for the two types of Ethernet cables are shown below:

Pins:

12345678

Side View

Insert

Twisted

Pair Wires

RJ-45 Connector

Straight-through Cable

(for connection to a switch, hub, or router)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-orange
2	orange	2	orange
3	white-green	3	white-green
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	green
7	white-brown	7	white-brown
8	brown	8	brown

Crossover Cable

(for direct connection to a PC)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-green
2	orange	2	green
3	white-green	3	white-orange
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	orange
7	white-brown	7	white-brown
8	brown	8	brown

NThe diagram is representative of both the patch (straight-through) and the crossover cable. Both types of cables have twisted pairs of conductors inside the sheath.

Serial Device Connection

There are two types of serial connections:

•9-pin D connectors

•Captive screw connectors

IPL T S Series Interfaces • Hardware Setup

2-5

Image 17

Contents Interfaces IPL T S SeriesSafety Instructions English Precautions安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces OneIPL T S Series Products IntroductionAbout this Manual IPL T S1 Introduction, cont’d Global Configurator Click the Global Configurator icon Installing Global ConfiguratorSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Front Panel Hardware SetupRear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power ConnectionSerial Device Connection RJ-45 Connector Straight-through CableCaptive screw connector Hardware Setup, cont’dPin D connector IPL T S6 Hardware Setup, cont’d Three Creating a Global Configurator Project File Software SetupStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Step two create a new project Software Setup, cont’dIPL T S Series Interfaces Software Setup Click Make this device a GlobalViewer Host if desired Step three add a deviceClick Edit Add Device Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Click Edit Contact Manager Software Setup, cont’d Configuring a New DeviceStep six configure contacts Click Edit Email Manager Step seven configure e-mailClick Add Driver Driver Configuration tab opensStep eight assign device drivers Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click ConditionsApply Email/Contacts Step eleven build the Global Configurator fileBuilding and Uploading a GC File Step twelve upload the Global Configurator file Set Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step thirteen change device settings if desiredClick Tools Change Device Settings Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer InterfaceIPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s WarrantyExtron USA East Setup Guide Checklist