Extron electronic IPL T S6, IPL T S4, IPL T S1 Software Setup, cont’d Configuring a New Device

Page 30

Software Setup, cont’d

Configuring a New Device

Step six: configure contacts

The Contact Manager dialog box is used to enter the name, e-mail address, and company name of the network’s contacts.

To configure contacts:

1. Click Edit > Contact Manager...

2. Complete the Name, Email, and Company fields.

3. Click Add. The contact information is added.

4. Click OK.

3-10 IPL T S Series Interfaces • Software Setup

Image 30

Contents IPL T S Series InterfacesPrecautions Safety Instructions English安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series InterfacesIntroduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator System requirements Installing Global ConfiguratorClick the Global Configurator icon Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Hardware Setup Front PanelRear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN ConnectionRJ-45 Connector Straight-through Cable Serial Device ConnectionHardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Step one download device drivers Software SetupCreating a Global Configurator Project File Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Software Setup, cont’d Step two create a new projectIPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Step seven configure e-mail Click Edit Email ManagerDriver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply ConditionStep eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewerIPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central AmericaSetup Guide Checklist Extron USA East