Extron electronic IPL T S4, IPL T S1 Introduction, About this Manual, IPL T S Series Products

Page 8

Introduction

About this Manual

This setup guide describes the:

•IPL T S Series products

•Global Configurator application

•IPL T S Series hardware installation

•IPL T S Series software configuration

IPL T S Series Products

The Extron IPL T S Series interface boxes can be installed as nodes on an Ethernet-based audio/video (A/V) network.

They can be used to remotely monitor and control connected A/V devices such as projectors, displays, VCRs, DVD players, and lighting systems, etc.

Lighting

Control

		3
		COM
	1	2
	COM	COM
	2
093012052	COM
093012052
UID#
LAN
POWER
12V MAX
.5A

Extron

IPL T S4

Ethernet Control Interface with GlobalViewero software

RS-232

Laptop

DV

D

AY	VCR
DISPL	VCR
POWER

206

TCP/IP

Network

RS-232

Ethernet

Remote User

Control &

Administrator

Monitoring

VOLUME	MLC
VOLUME
MAX

MIN

Extron

Extron

MLC 206

MediaLinko Controller

Projector

Laptop DVD

VCR

Typical IPL T S Series Interface application

1-2 IPL T S Series Interfaces • Introduction

Image 8

Contents IPL T S Series InterfacesPrecautions Safety Instructions English安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series InterfacesIPL T S Series Products IntroductionAbout this Manual IPL T S1 Introduction, cont’d Global Configurator Installing Global Configurator Click the Global Configurator iconSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Hardware Setup Front PanelRear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN ConnectionRJ-45 Connector Straight-through Cable Serial Device ConnectionCaptive screw connector Hardware Setup, cont’dPin D connector IPL T S6 Hardware Setup, cont’d Three Software Setup Creating a Global Configurator Project FileStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Software Setup, cont’d Step two create a new projectIPL T S Series Interfaces Software Setup Click Make this device a GlobalViewer Host if desired Step three add a deviceClick Edit Add Device Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Click Edit Contact Manager Software Setup, cont’d Configuring a New DeviceStep six configure contacts Step seven configure e-mail Click Edit Email ManagerClick Add Driver Driver Configuration tab opensStep eight assign device drivers Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply ConditionApply Email/Contacts Step eleven build the Global Configurator fileBuilding and Uploading a GC File Step twelve upload the Global Configurator file Set Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step thirteen change device settings if desiredClick Tools Change Device Settings Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewerIPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central AmericaSetup Guide Checklist Extron USA East