Extron electronic IPL T S1, IPL T S4 Step nine set scheduled actions and e-mail deliveries

Page 33

Step nine: set scheduled actions and e-mail deliveries

The Schedule tab is used to set scheduled actions and e-mail deliveries. A single schedule can include both actions and e-mail assignments.

To schedule an action:

1. Click the Schedule tab.

2. Click the Add Schedule button.

The Scheduled Actions Wizard dialog box opens.

IPL T S Series Interfaces • Software Setup 3-13

Image 33

Contents Interfaces IPL T S SeriesSafety Instructions English Precautions安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces OneIntroduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Click the Global Configurator icon Installing Global ConfiguratorSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Front Panel Hardware SetupRear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power ConnectionSerial Device Connection RJ-45 Connector Straight-through CableHardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Creating a Global Configurator Project File Software SetupStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Step two create a new project Software Setup, cont’dIPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Click Edit Email Manager Step seven configure e-mailDriver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click ConditionsStep eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer InterfaceIPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s WarrantyExtron USA East Setup Guide Checklist