Extron electronic IPL T S4, IPL T S1, IPL T S6, IPL T S2 setup guide Introduction, cont’d

Page 12

Introduction, cont’d

1. Insert the Extron Software Products CD into your drive.

2. Wait for the Extron Software Products page to load.

3. Click on the Software icon.

4. Scroll down to the Global Configurator description and click the Install link in the far right column.

5. Follow the remaining system prompts.

To install Global Configurator from an Extron Software Products CD if Autorun is not enabled on your PC:

1. Insert the Extron Software Products CD into your drive.

2. From the Windows desktop, open My Computer and select the CD-ROMdrive.

3. Double click launch.exe.

4. Wait for the Extron Software Products page to load.

5. Click on the Software icon.

6. Scroll down to the Global Configurator description and click the Install link in the far right column.

7. Follow the remaining system prompts.

1-6 IPL T S Series Interfaces • Introduction

Image 12

Contents IPL T S Series InterfacesPrecautions Safety Instructions English安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series InterfacesIntroduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Installing Global Configurator Click the Global Configurator iconSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Hardware Setup Front PanelRear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN ConnectionRJ-45 Connector Straight-through Cable Serial Device ConnectionHardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Software Setup Creating a Global Configurator Project FileStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Software Setup, cont’d Step two create a new projectIPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Step seven configure e-mail Click Edit Email ManagerDriver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply ConditionStep eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewerIPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central AmericaSetup Guide Checklist Extron USA East