Extron electronic FOX T USW 103 manual Making Connections, Control Connectors, Power Connector

Page 12

Control Connectors

FContact closure connector — Connect a contact closure device (such as a simple switch) to the 3.5 mm, 4-pole captive screw connector. The first three ports are used for selecting inputs 1 through 3 when momentarily shorted to the ground pin (see Wiring for Remote Contact Closure Communication on page 8).

GRS-232 connector — Connect a host device to the 3.5 mm, 3-pole captive screw connector for serial control of the switcher.

Power Connector

HPower connector — Connect an external power supply to the 3.5 mm, 2-pole captive screw connector (see Wiring the Power Supply on page 9).

Making Connections

Connecting HDMI Connectors

Use an Extron LockIt Lacing Bracket to secure an HDMI cable to each device as follows:

3

4

2

5 1

Figure 4. Installing the LockIt Lacing Bracket

1.Plug the HDMI cable into the panel connector.

2.Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt lacing bracket to be placed over it. The screw does not have to be removed.

3.Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten the screw to secure the bracket.

ATTENTION: Do not overtighten the HDMI connector mounting screw. The shield to which it is fastened to is very thin and can easily be stripped.

4.Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket as shown.

5.While holding the connector securely against the lacing bracket, use pliers or a similar tool to tighten the tie wrap, then remove any excess length.

FOX T USW 103 Universal Switcher • Installation

6

Image 12
Contents FOX T USW Safety Instructions English Chinese Simplified(简体中文) FCC Class a Notice FDA/IEC 60825-1 Requirements Class 1 Laser ProductSpecifications Availability Software CommandsConventions Used in this Guide NotificationsContents FOX T USW 103 Universal Switcher Contents Introduction About This GuideAbout the FOX T USW System CompatibilityKey Features Contact closure remote control availabilityHDCP-compliance Application Diagram Typical FOX T USW 103 ApplicationInstallation Rear Panel FeaturesInput Connectors Mounting the FOX T USWFiber Optic Connector RS-232 Over Fiber and Alarm ConnectorControl Connectors Power ConnectorConnecting Hdmi Connectors Making ConnectionsWiring for Fiber Communication Wiring for RS-232 Over Fiber and Alarm Communication Wiring for Remote Contact Closure CommunicationWiring the Power Supply Power Connector WiringFront Panel Features OperationFront Panel Operation Front Panel Button Combinations for Device ModesInitial Power Up Enabling Auto Switch ModeEnabling Normal Switch Mode Selecting an InputSIS Configuration Control Simple Instruction Set ControlSIS Programming Guide Host-to-device and device-to-host communicationError responses Using the command and response table for SIS commandsSymbol definitions VGA PC SIS Command and Response Tables for SIS Commands Input SwitchingAudio Configuration Picture Adjustment Analog Only Pixel phaseTotal pixels Horizontal startAdvanced Configurations Device name Information requestsStatus request View internal temperature Factory resetUpload firmware SFP moduleInstalling the Software To install the software from the DVDFOX Extenders Control Program To download the software from the websiteUsing the Software Starting the SoftwareTop Menu File menuConnect DisconnectExit Tools MenuReset Unit Unit InfoUpdate Firmware To update firmwareRefresh Trace WindowContents Check for UpdatesExtron Home About About FOX Extenders Control Program Dialog BoxMain Screen Status panelInput Selection panel Control tabVGA Video Adjustment panel VGA Video Adjustment PanelAudio Adjustment panel Configuration TabHdcp panel Plus Mode Transmission panel VGA Input Video Format panelAudio Input Selection panel Advanced TabAdvanced Configuration panel Edid Configuration TabAssigned Edid panel Save Edid panelImport Edid panel Import Edid PanelExport Edid panel Export Edid PanelReference Information MountingTabletop Use Mounting KitsInstalling Firmware Loader Updating FirmwareDownloading Extron Firmware Loader Downloading Firmware Downloading Firmware from the Extron WebsiteInstalling Firmware with Firmware Loader Add Device... WindowExtron Warranty