Extron electronic ISM 824 manual OUT #5, Picture adjustments, Press the Esc button, Presets

Picture adjustments

The ISM 824 has six buttons for picture adjustment modes (color/tint, brightness/ contrast, detail, position, size, and zoom).

COLOR/	BRIGHT/	DETAIL POSITION	SIZE	ZOOM
TINT	CONT

PICTURE ADJUSTMENTS

To make picture adjustments do the following:

1. Press the Esc button.

2. Press the applicable picture adjustment button (lights amber). Associated output buttons for cards that allow adjustments light steady or flash green. If flashing, press the button to select (lights green).

NSteady lit buttons indicate currently selected outputs, and flashing buttons indicate outputs available for selection.

Step 2.

Press the Color/Tint button.

The button lights amber.

COLOR/	BRIGHT/	DETAIL POSITION	SIZE	ZOOM
TINT	CONT

PICTURE ADJUSTMENTS

Presets

The ISM 824 has a total of sixteen I/O preset memory addresses available that are assigned to the input and output buttons. They can be saved and recalled using the front panel and any current tie configuration can be saved to any one of the preset locations, in any order.

NSaving the current configuration to an existing preset overwrites that existing preset in favor of the new configuration.

To save or recall a preset, do the following:

1. Press the Esc button.

2. Press and hold (2 seconds for save) or press and release the Preset button (to recall). The Preset button either flashes red (save) or lights red (recall).

3. Select the desired input or output button for the appropriate preset number (1-16) to save to or recall from. That button and the Enter button flash red.

Step 2. Press the Preset button

To save a preset To recall a preset

PRESET 2 seconds PRESET OR PRESET PRESET

Press and	Preset button	Press and	Preset button
hold	flashes red.	release	lights red.

	COL	OUT #5		TINT				Step 3. Select desired preset #
										Preset numbers (1-16)
	128			128				1	2	3	4	5	6	7	8
NThe LCD shows the current Color/Tint setting.											INPUTS
								1	2	3	4	5	6	7	8
			INPUTS
1	2	3	4	5	6	7	8	1	2	3	4	5	6	7	8
											OUTPUTS
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16
								Whenever the preset button is pressed, currently saved
			OUTPUTS					preset buttons light red (e.g. presets #’s 3, 5,and 15).
								Select a new					Select an existing
The applicable output card button (#5) and associated
								preset # to save to.					preset to recall.
input (#2) light green. Applicable available outputs flash
green.									6					3
Step 3.						ADJUST					OR
Use the encoders to make
the adjustment.								Step 4. Press the flashing Enter button to excute.

3. Use the appropriate encoder to make the desired adjustments.

4. Press the Esc button to exit. The buttons extinguish.

See chapter 3, “Operation and Setup”, “Picture adjustments” section, for information about all picture adjustment settings.

ENTER

4. Press Enter. All preset buttons and the Enter buttons extinguish. The current configuration is saved to or retrieved from the selected preset location.

See chapter 3, “Operation and Setup”, “I/O presets” section, for further information.

ISM 824 Integration Scaling Multiswitcher • Quick Start QS-3