Extron electronic IPI 200 Series, IPI 100 Series manual Remapping port designations

5-24 IPI 100 Series, IPI 200 Series • Programming and Control

Command	ASCII (Telnet)	URL Encoded (Web)	Response	Additional
	(host to intercom)	(host to intercom)	(intercom to host)	description

Remapping port designations

For security reasons the network administrator may wish to assign new/different port numbers to the controller’s Telnet, Web browser, and direct access ports or to disable one or more ports. Typically Telnet uses port 23, Web access is via port 80 (HTTP), and direct access is via port 2001.

CDo not set two or more ports to the same port number. Setting two ports to the same number could cause networking conflicts and will also result in an E13 (invalid parameter) error.

NIf you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the port by setting it to 0.

Set the Telnet port	E {port#}MT }	W{port#}MT	Pmt {port#} ]	Select a number for the port
map24				that will not conflict with any
				other ports.
Reset the Telnet	E 23MT }	W23MT	Pmt 00023 ]	This resets the Telnet port to
port map24				port 23.
Disable the Telnet	E 0MT }	W0MT	Pmt 00000 ]	Setting the port number to 0
port map24				disables the port.
Read the Telnet	E MT }	WMT	{port#} ]
port map
Set the Web port	E {port#}MH }	W{port#}MH	Pmh {port#} ]
map24
Reset the Web	E 80MH }	W80MH	Pmh 00080 ]	This resets the Web port to
port map24				port 80.
Disable the Web	E 0MH }	W0MH	Pmh 00000 ]
port24
Read the Web	E MH }	WMH	{port#} ]
port map

IPI 201/204 SIS™ Programming, cont’d