Extron electronic System 7SC manual Initiating IR learning

Operation and Configuration, cont’d

Initiating IR learning

Extron

System 7SC

MENU

SWITCHER SETUP/ CONFIGURATION

MENU

AUDIO/VIDEO

If an IR command from the display’s remote control has not already been programmed into the System 7, a driver is unavailable, or an update is needed, IR learning is the best, fastest way to load that command into the System 7. Use the flowchart below as a guide to IR learning.

IR learning will automatically replace any old commands from the buttons you are programming. If no IR signal is received by the System 7 during IR learning, the previously stored IR commands are not cleared; they remain in that button’s memory.

ADJUSTMENTS

MENU

IR LEARNING

CONFIGURATION

NEXT

Input #1

Status: Clear

Input #1

Learn?

Repeat all steps for each

button to be learned.

				Input #1
				Status: Saved
	The LCD and the front panel button flash
	every half second until the IR signal
	is learned (up to 6 sec.).
				Signal has been learned
NEXT	Input #1
	IR Learning!
				Signal was not learned
	Point the projector's			2 seconds
	IR remote control
	at the System 7SC's	ADJUST
	IR Learn porthole.		VOLUME
	Briefly press the	DISPLAYIR		Input #1
	desired button on	RX LEARN		Retry!
		TX
	the remote.	RX	SYSTEM 7SC

If the IR signal is not detected by the System 7SC, after

3 cycles the switcher exits IR learning and returns to the button's status screen.

Initiating IR learning

3-16 System 7SC • Operation and Configuration