Gigabyte GS-R12T4H2-RH manual Serial ATA, Sata Port 0/1/2/3/4/5

BIOS Setup

Serial ATA

Enabled	Enables on-board serial ATA function. (Default setting)
Disabled	Disables on-board serial ATA function.

Native Mode Operation

This option allows user to set the native mode for Serial ATA function.

Auto	Auto detected. (Default setting)
Serial ATA	Set Native mode to Serial ATA.
SATA Controller Mode Option
Compatible Mode		SATA and PATA drives are auto-detected and placed in
		Legacy mode.
Enhanced Mode		SATA and PATA drives are auto-detected and placed in
		Native mode. (Default setting)
Note: Pre-Win2000 operating system do not work in Enhanced mode.
SATA RAID Enable
Enabled		Enabled SATA RAID function.
Disabled		Disable this function. (Default setting)
SATA AHCI Enable
Enabled		Set this item to enable SATA AHCI function for WinXP-SP1+IAA
		driver supports AHCI mode.
Disabled		Disabled this function. (Default setting)

SATA Port 0/1/2/3/4/5

The category identifies the types of Serial SATA hard disk from drive 0 to 5 that has been installed in the computer. System will automatically detect HDD type.

Note that the specifications of your drive must match with the drive table. The hard disk will not work properly if you enter improper information for this category.

Hard drive information should be labled on the outside device casing. Enter the appropriate option based on this information.

TYPE

1-39: Predefined types.

Users: Set parameters by User.

6 3