ATTO Technology, Inc. | ATTO FibreBridge Installation & Operation Manual | |
SCSI TERMINATION | 21 | |
FIBRE CHANNEL CABLING | 22 | |
GBICS | 22 | |
GBIC MODULE AND GBIC GUIDE SYSTEM | 23 | |
GBIC INSTALLATION INSTRUCTIONS | 23 | |
GBIC REMOVAL INSTRUCTIONS | 24 | |
MEDIA INTERFACE ADAPTERS (MIA) | 24 | |
MIA INSTALLATION | 25 | |
CHAPTER 7: FIBREBRIDGE SERVICES | 26 | |
MONITORING AND MANAGING THE ATTO FIBREBRIDGE | 26 | |
ATTO BRIDGETOOLS GRAPHICAL INTERFACE CONFIGURATION PROGRAM | 26 | |
ACCESSING THE ATTO FIBREBRIDGE OVER THE | 26 | |
ACCESSING THE ATTO FIBREBRIDGE OVER THE ETHERNET PORT | 27 | |
Setting up the IP Address using the | 27 | |
Accessing the ATTO FibreBridge using a Telnet session over Ethernet | 28 | |
Accessing through FTP | 28 | |
CHAPTER 8: SERVERLESS BACKUP SUPPORT | 30 | |
WHAT IS SERVERLESS BACKUP ? | 30 | |
TARGET DESCRIPTORS | 31 | |
SEGMENT DESCRIPTORS | 31 | |
GENERAL OPERATION OF SERVERLESS BACKUP | 31 | |
ENABLING SERVERLESS BACKUP ON THE FIBREBRIDGE | 31 | |
CHAPTER 9: UPDATING THE FIRMWARE WITHIN THE FIBREBRIDGE | 32 | |
FLASHING THE FIBREBRIDGE | 32 | |
CHAPTER 10: ADDRESSING SCSI DEVICES | 33 | |
IDENTIFYING THE FIBREBRIDGE | 33 | |
IDENTIFYING THE SCSI DEVICES CONNECTED TO THE FIBRE BRIDGE | 34 | |
DEFAULT ADDRESS TRANSLATION | 35 | |
APPENDIX A: FIBRE CHANNEL TO SCSI ADDRESS MAPPING | 36 | |
FIBRE CHANNEL WORLD WIDE NAME (WWN) | 37 | |
ARBITRATED LOOP PORT ADDRESS (AL_PA) | 37 | |
SCSI BUS IDENTIFIER | 37 | |
SCSI TARGET IDENTIFIER | 38 | |
SCSI LOGICAL UNIT NUMBER | 38 | |
WHAT IS A LOGICAL UNIT ? | 38 | |
HIERARCHICAL ADDRESSING MODEL | 38 | |
ADDRESSING FIELD FORMAT | 38 | |
PERIPHERAL DEVICE ADDRESSING METHOD | 39 | |
VIRTUAL DEVICE ADDRESSING METHOD | 40 | |
LOGICAL UNIT ADDRESSING METHOD | 40 | |
FIBREBRIDGE DEFAULT MODE | 40 | |
ADDRESS DESCRIPTORS | 41 | |
41 | ||
42 | ||
SETTING THE ID OF THE FIBREBRIDGE | 42 | |
ADDRESSING CONNECTED SCSI DEVICES | 42 | |
CONFIGURATION FOR CONSECUTIVE IDS | 44 | |
CONFIGURATIONS FOR RAID CONTROLLERS | 44 |
ATTO Technology, Inc.
- iii -