Tripp Lite 700 RM UPS owner manual Installation

	Installation
1	Install rack handles
	(supplied) and mount
	UPS in standard
	19 in. rack using
	standard rack hardware
	(user supplied).
	Install your UPS in the lowest rack position
	possible.
2	Plug your UPS into
	an electrical outlet.

Your UPS should occupy a 15-amp dedicated circuit.

3	Plug your equipment into
	your UPS.

Your UPS is designed to support only computer equipment. Connecting household appliances, laser printers or surge suppressors is not recommended.

4	Turn your UPS ON.		System Enable Switch
	Set the System Enable Switch to the
			Located on Front Panel
	“ENABLE” position.		("I" = ENABLE;
	This switch activates the battery charger and		"O" = DISABLE)
	microprocessor.
	The “	” light will flash until you engage the
	ON/Standby Switch to activate the “ON”
	mode.
	Engage the momentary ON/Standby
	Switch (UPS front panel) and release it		ON/Standby Switch
	to activate the “ON” mode and supply		Located on Front Panel
	power to the UPS receptacles.

3