Network Technologies SM-nXm-15V-LCD operation manual Change Password, Help, Update Web Server

Page 24

NTI VEEMUX VIDEO MATRIX SWITCH

Change Password Page

Figure 16- Web interface Password page

Use this page to change the password for accessing the web interface. (This password is also used for the telnet interface.) Be sure to make note of the new password exactly as it is case sensitive. The password must be between 5 and 16 characters in length and can be alphabetical or numeric.

Help Page

This page explains the purpose of each of the other pages in the VEEMUX web interface.

Update Web Server

Click on this selection to globally update the Web Server to any settings that have been changed though Telnet, the RS232 interface, or via the front panel of the VEEMUX. All users presently connected will be disconnected and must log back in after using this command.

Figure 17- Updating the Web Server

Image 24

Contents SM-nXm-15V-LCD Trademark Table of Contents Table of Figures Introduction Basic OperationSupported Web Browsers CompatibiltyDefault User Name and Passwords MaterialsCables Materials Supplied with this kitFeatures and Functions Power ON/OFF switchFront View of SM-8X8-15V-LCD Installation Connect the Sources and Monitors9D-male RS232 connector Connect RS232Connect to the Ethernet Power Up LED MatrixControl Options Front Panel LCD with Keypad ControlEscape back to the main display Used to enter numbers. # Output user number can be enteredScan Mode RS232 ControlRemote Connection Command Protocol Baud RateUnit Address RS232 Matrix-Y-1 CPU Serial PortCommand Definitions Contd AutostatusSerTest- RS232 Interface Test Program Main OptionsMatrix Operations Setup Options Ethernet OperationsCommand Reply Description Ethernet ControlTelnet Interface Telnet 192.168.1.30Enter the Password Web InterfaceVideo Switch Web interface SwitchSetup Pages Web interface SetupWeb interface Serial Setup Video Input NamesScan Mode Output NamesUpdate Firmware Web interface Update FirmwareChange Password Update Web ServerHelp Logout Web interface LogoutDevice Discovery Tool Device Discovery ToolFeatures And Functions Infrared ControlKeypad LCD DisplayHow To Use The IRT Change the SwitchPower on with SYS, in or OUT keys Power on with 2 key Change Output Port Change Input PortSet Configuration Battery Replacement SpecificationsIRT Troubleshooting Insert 2 new AA cell batteriesDDC Support RS232 Upgrade of the Front Panel LCD Firmware Following will be neededNTI Veemux Video Matrix Switch RS232 Connection Cables Pinout of RS232 port on VeemuxWiring Schematic of Matrix-Y-1 cable Arrows indicate signal directionPinout for Matrix Y-1 Cable Rack Mounting InstructionsSpecifications NTI Desktop Size Rack Units Rack Size In. WxDxHTroubleshooting Safety StatementsWarranty Information Index