Network Technologies SM-nXm-15V-LCD operation manual Setup Pages, Web interface Setup

Page 20

NTI VEEMUX VIDEO MATRIX SWITCH

To save a configuraton, from the Stored Configurations user interface, use the drop-down list to select the desired slot (numbers 0-99) to save the active configuration into and press the Save button.

Note: This will save the currently active configuration on the VEEMUX. If changes have been made in the web interface without first pressing the Submit button, those changes will not yet be part of the active configuration.

Note: If changes to the active configuration have been made by another user prior to saving the current connection selections, the changes made by the other user will be saved as the configuration.

The webpage configuration that loads after a Save is the configuration that was actually saved.

To load a saved configuration, from the Stored Configurations user interface, use the drop-down list to select the desired configuration. Then press the Load button. The VEEMUX will make the connections and the screen will refresh to show the connections associated with that configuration selection.

FYI: Configurations saved via the keypad (pg. 7) can be recalled through this interface, and vice versa. They are one in the same.

Setup Pages

These settings enable the user to configure the VEEMUX web interface connection. This change will take a few seconds and automatically redirect the user to the IP address specified.

Note: Since the webserver will be restarting all active connections will be logged out.

The Website Timeout option controls how long an inactive web connection will stay logged in.

Any change to the Website Timeout configuration takes effect immediately.

Figure 10- Web interface Setup page

16

Page 19 Page 21
Image 20
Page 19 Page 21
Contents SM-nXm-15V-LCD Trademark Table of Contents Table of Figures Introduction Basic OperationSupported Web Browsers CompatibiltyDefault User Name and Passwords MaterialsCables Materials Supplied with this kitFront View of SM-8X8-15V-LCD Features and FunctionsPower ON/OFF switch Installation Connect the Sources and MonitorsConnect to the Ethernet 9D-male RS232 connectorConnect RS232 Power Up LED MatrixControl Options Front Panel LCD with Keypad ControlEscape back to the main display Used to enter numbers. # Output user number can be enteredRemote Connection Scan ModeRS232 Control Command Protocol Baud RateUnit Address RS232 Matrix-Y-1 CPU Serial PortCommand Definitions Contd AutostatusMatrix Operations SerTest- RS232 Interface Test ProgramMain Options Setup Options Ethernet OperationsCommand Reply Description Ethernet ControlTelnet Interface Telnet 192.168.1.30Enter the Password Web InterfaceVideo Switch Web interface SwitchSetup Pages Web interface SetupWeb interface Serial Setup Video Input NamesScan Mode Output NamesUpdate Firmware Web interface Update FirmwareHelp Change PasswordUpdate Web Server Logout Web interface LogoutDevice Discovery Tool Device Discovery ToolFeatures And Functions Infrared ControlKeypad LCD DisplayPower on with SYS, in or OUT keys Power on with 2 key How To Use The IRTChange the Switch Change Output Port Change Input PortSet Configuration Battery Replacement SpecificationsIRT Troubleshooting Insert 2 new AA cell batteriesDDC Support RS232 Upgrade of the Front Panel LCD Firmware Following will be neededNTI Veemux Video Matrix Switch RS232 Connection Cables Pinout of RS232 port on VeemuxWiring Schematic of Matrix-Y-1 cable Arrows indicate signal directionPinout for Matrix Y-1 Cable Rack Mounting InstructionsSpecifications NTI Desktop Size Rack Units Rack Size In. WxDxHTroubleshooting Safety StatementsWarranty Information Index
Top Page Image Contents